Jump to content

How To Do The Big 3: Tutorial


Guest MegaloManiac

Recommended Posts

  • 2 weeks later...
  • 2 weeks later...

hey guys i have a 2010 mazda 3 with 2 12 2 12 BOSS CX124DVC Chaos Exxtreme 12" DVC Subwoofer and Kenwood Kac-9105D 1800-Watt Class D Mono Amplifier. i want to do the big 3 but idk what gauge wire should i use. and i want to do the wiring of the amp again because i have some flea market kit.

2010 Mazda 3

*Rebuild Time*

Subs - (2) AA Mayhems 12's
Sub amp - (1) Populus Audio TPA 6500
Headunit - Pioneer App Radio 2

Batteries - XS Power (1) D3100 up front | 6 XP950 rear

Wire - Sky High 1/0 Gauge wires and RCA's and steve's VM1

Alternator - Singer 260 Externally Regulated

Front Stage: (2) PRV Audio 10W650A (4) PRV Audio 8MR500-PhP-4 (4) DS Bullet Tweets | (2) 6.5 Components (Rear doors)

Mids & high Amp : (2) Populus Audio 100.4

Processor: Rockford 3sixty.3



The Build Log : http://www.stevemeadedesigns.com/board/topic/175922-2010-mazda-3-2-aa-mayhems-12-pg14-new-video/page-11

flakosignature1-1_zps0751010a.png

Link to comment
Share on other sites

  • 1 month later...

I have a 2007 chevy impala ss that I just recently went to do the big 3 on and noticed my power wire from my alt went to the bottom right side of my engine somewhere then back up to my battery so I figured I would just run it direct to the battery anyway and I can drive my car around for about 20 to 30 minutes then my dash lights up saying "battery saver active" like it does right before my battery usually dies but I can shut my car off and it starts right back up anyone have any ideas of what is going on, I was thinking it goes through a regulator or something

Link to comment
Share on other sites

  • 4 weeks later...

I have a '94 Mazda B2300(Ford Ranger copy). My alternator positive runs to the starter solenoid. My question is, adding a run from the alternator straight to the battery is ok?

I swear that shit shot out into the parking lot too. Very dangerous, but fun.

94' Mazda B2300. Logic Soundlab 1000.2 amp pushing a DD 1010(1.56ft^ft@37hz). KnuKoncepts wiring. Pioneer headunit. Homemade C.A.I. Cat delete. N1 muffler.

Link to comment
Share on other sites

  • 3 weeks later...
  • 1 month later...

Just curious noob question do u leave stock wires ran as well or totally replace them with big 3???

On 3/28/2014 at 4:22 PM, KyLar96 said:

Its all about the music anyway..... Do a proper install, something your happy with, Fuck everyone else...... improve in time, where you can..... its not rocket science...

Tiburon build //www.stevemeadedesigns.com/board/topic/174059-97-hyundai-tiburon-build-from-ramming-to-slamming-slow-5k-build/

2000 Mountaineer build http://www.stevemeadedesigns.com/board/topic/186736-2000-mountaineer-build-from-ramming-to-slamming-part-iislow-5k-builddc-audio-americanbassxspowersingerarcaudiostingershcavideo-on-pg7/

2000 Mercury Mountaineer: Electrical:Singer 360 hairpin powdercoated white alt, Big 4 double run 1/0 SHCA OFC, 4 runs 1/0 OFC SHCA, limitless 70ah, HU: Pioneer deh80prs interiors: Skar sk85.4 on sb acoustics neo dome tweeters 2 Mmats sq4100s on 4 silver flute 8s(4ohm) SUB Stage: 3 DC5K [email protected] on 6 ascendant audio mayhem 12s d1.4s fully loaded

Link to comment
Share on other sites

leave them in place

THERE IS NO BUILD LOG!

1998 Chevy Silverado ext cab

Alpine CDA-9887

4 Team Fi 15s

2 Ampere Audio TFE 8.0

2 Ampere Audio 150.4

3 Digital Designs CS6.5 component sets

Dual Mechman 370XP Elite alternators inbound!

8 XS Power d3400

6 XS power d680

Second Skin

Stinger

Tsunami Wiring

Sky High

A Real Voltmeter not a piece of shit stinger.

Link to comment
Share on other sites

Thankyou

On 3/28/2014 at 4:22 PM, KyLar96 said:

Its all about the music anyway..... Do a proper install, something your happy with, Fuck everyone else...... improve in time, where you can..... its not rocket science...

Tiburon build //www.stevemeadedesigns.com/board/topic/174059-97-hyundai-tiburon-build-from-ramming-to-slamming-slow-5k-build/

2000 Mountaineer build http://www.stevemeadedesigns.com/board/topic/186736-2000-mountaineer-build-from-ramming-to-slamming-part-iislow-5k-builddc-audio-americanbassxspowersingerarcaudiostingershcavideo-on-pg7/

2000 Mercury Mountaineer: Electrical:Singer 360 hairpin powdercoated white alt, Big 4 double run 1/0 SHCA OFC, 4 runs 1/0 OFC SHCA, limitless 70ah, HU: Pioneer deh80prs interiors: Skar sk85.4 on sb acoustics neo dome tweeters 2 Mmats sq4100s on 4 silver flute 8s(4ohm) SUB Stage: 3 DC5K [email protected] on 6 ascendant audio mayhem 12s d1.4s fully loaded

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 1180 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...