Jump to content
Sundown Audio

What you guys think?


islandpride684

Recommended Posts

  • Replies 60
  • Created
  • Last Reply

Thanks for sharing

Im lost as to what he means by the banda needs high voltage, does he mean solid 14V voltage? like no drop at all?

He keeps saying the brazilians are alot cheaper, but you have to dump a ton of more money into getting your electrical up to par.

Link to comment
Share on other sites

And if you ask someone else they tell you high voltage bad. I wish that they would figure out what you're really supposed to do. 1 plonk rated run it at two ohm two ohm rating run at four. Oh wait lee voltage over 14 no wait it's keenit under 14 they are 12 volt amps. So much conflicting info

THERE IS NO BUILD LOG!

1998 Chevy Silverado ext cab

Alpine CDA-9887

4 Team Fi 15s

2 Ampere Audio TFE 8.0

2 Ampere Audio 150.4

3 Digital Designs CS6.5 component sets

Dual Mechman 370XP Elite alternators inbound!

8 XS Power d3400

6 XS power d680

Second Skin

Stinger

Tsunami Wiring

Sky High

A Real Voltmeter not a piece of shit stinger.

Link to comment
Share on other sites

Idk what he means by high voltage. There are a few simple rules to running Brazilian: dont go higher then 15 volts, dont go lower then 11, dont wire below nominal impedance.

3 easy steps to follow the same way you wouldnt buy a gas powered car fill the tank with water then complain its junk most people do the opposite of the 3 rules then complain. And no actually you dont need to spend a ton on electrical to keep them going they are far more efficient then korean amps so for example my banda 3500 will pull just as much if not less then your 1500 watt korean whatever amp. The killer part is the unparalleled sound quality of the Banda id easily compare to the JL slash series.

2003 Mercury Grand Marquis LS (CVB 25th Chapter)

Alpine Head Unit

stock 6x9's

Powerbass ASA 1500.1Dx

FC 1200 krank-it up battery

HC 800 Kinetik battery

Orion HCCA 12.4 in slot ported box wired down to 2 ohms

Audiopipe 1/0 gauge wire

Rockford fosgate ring terminals

Subscribe to the Youtube page

http://www.youtube.com/user/TManMusicPage

Link to comment
Share on other sites

That is of course unless hes talking about the 110 volts output of the 1 ohm amps and 220 volt output of the 2 ohm versions.

2003 Mercury Grand Marquis LS (CVB 25th Chapter)

Alpine Head Unit

stock 6x9's

Powerbass ASA 1500.1Dx

FC 1200 krank-it up battery

HC 800 Kinetik battery

Orion HCCA 12.4 in slot ported box wired down to 2 ohms

Audiopipe 1/0 gauge wire

Rockford fosgate ring terminals

Subscribe to the Youtube page

http://www.youtube.com/user/TManMusicPage

Link to comment
Share on other sites

Here is a comment left elsewhere in regards to someone who knows more about it then I:

Brazilian amps dont like recommended resistance . If it says 1 ohm there saying to stay above that because there looking for your box rise . There tricky . If you give the amp 15v and you have a 1 ohm after rise your amp will pop. But if the input voltage is around 12-13 the amp last a little bit longer but still have the chance of popping . The amps look for 2-3-4 ohms . Brazilian amps work off your voltage/wattage not as much as amperage. So the "high voltage " is whats coming out of the amp . Brazilian 5k amp may give you 130 volt output at 40 amps@ 5,200 watts compared to a korean 5k may give you 87 volts at 60 amps@ 5,220 watts. <---- ohms law v×I=p where v is voltage I is amperage and p is powere . And too find you rise v÷I=r r is resistance. Post this on that page . I hope this dumbs it down for him .

2003 Mercury Grand Marquis LS (CVB 25th Chapter)

Alpine Head Unit

stock 6x9's

Powerbass ASA 1500.1Dx

FC 1200 krank-it up battery

HC 800 Kinetik battery

Orion HCCA 12.4 in slot ported box wired down to 2 ohms

Audiopipe 1/0 gauge wire

Rockford fosgate ring terminals

Subscribe to the Youtube page

http://www.youtube.com/user/TManMusicPage

Link to comment
Share on other sites

I like how people just sit around and make up excuses for why the amps blow.

I'll keep my money with what's proven and durable,

you know know the stuff people don't have to come up with a million reasons for why it will blow.

That being said a lot of people's definition of "music" is a clipped 30 hz sine wave with some 80 IQ knuckle head grunting about committing crimes and his genitals.

Link to comment
Share on other sites

Idk what he means by high voltage. There are a few simple rules to running Brazilian: dont go higher then 15 volts, dont go lower then 11, dont wire below nominal impedance.

3 easy steps to follow the same way you wouldnt buy a gas powered car fill the tank with water then complain its junk most people do the opposite of the 3 rules then complain. And no actually you dont need to spend a ton on electrical to keep them going they are far more efficient then korean amps so for example my banda 3500 will pull just as much if not less then your 1500 watt korean whatever amp. The killer part is the unparalleled sound quality of the Banda id easily compare to the JL slash series.

which banda amp do you run to know all this?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   1 Member, 0 Anonymous, 206 Guests (See full list)




×
×
  • Create New...