kickass audio Posted June 21, 2016 Report Share Posted June 21, 2016 Welcome everyone, I am looking to sell part, well more like most of my system so I can downsize it and get back to having an actual SUV instead of just using the rear seat for cargo when I go on trips. I'm selling my DC Audio 5.0k, Ascendant Audio SMD 18 (dual 1 ohm) and 3 of my 4 xs power d3100's in my truck. With the DC audio 5k, i will toss in the current 1/0 OFC wires and the fuse holder for them with the amp. Subwoofer: The DC 5k works perfectly. The only downside to it is I cannot remember where I placed the remote wire for the bass knob however it works perfectly. I have never had it overheat or go into protect mode. It has been one hell of an amp. I replaced two of the 4 speaker outputs on the dc 5k with a heavier hex head screw that would better secure my 8ga speaker wire so that is the only modification I did to the amp. Looking to sell the DC 5.0k for $900 shipped or a reasonable offer. Batteries: I am looking to sell 3 of the 4 XS power d3100's I have in my truck. I currently have them all hooked up as the system is currently in use so I cannot disconnect them unless interest is made to do a float charge check on them for you. Currently the rear battery bank sits at 12.89v Looking to sell each one for $250 plus shipping each or $600 for all 3 plus shipping or a reasonable offer. And lastly the Ascendant Audio SMD 18" with dual 1 ohm coils. This sub was reconed about 4 years ago and setup with 8ga wire soldered directly to the tinsel leads and has about 3 feet of the 8ga wire on each lead with a ring terminal crimped on each end. I have a custom carbon fiber black & blue dustcap that was signed by Mr. Meade himself (forgive the bad glue job, it was my first time trying to glue a dustcap down and I put a little too much on it). Looking to sell the sub for $700 shipped. As with the other posts, willing to accept a reasonable offer. If you are local (within a 2 hour drive) I will sell the sub and the enclosure to you for the same price. 2004 GMC Envoy1 XS power S3400 batt under the hood and 4 XS Power D3100's battery installed in the rear by the amps0 gauge power wire from front to backAlpine iva-w205 touchscreen dvd/cd/mp3/ipod/am/fm/gps headunitSundown Audio SAX-200.4 amp for my mids and highs8 gauge speaker wire from amp to woofer270 amp Mechman AltRockford Fosgate T1652-s component speakersRockford Fosgate 3Sixty.2 sound processorRca's from Rockford Fosgate and Monster Cable14 gauge speaker wire for the mids and highs1 18" Ascendant Audio SMD Dual 1 ohm with custom Black & Blue carbon fiber and hand signed dustcapBox: 5.66 cubic feet net volume box tuned to 30.13Hz with 1.5" wide wooden dowels and 1.5" thick baffle1 DC Audio 5.0k amp wired to .5 ohms nominal with an imp rise of 1.35 ohms for the single AA SMD 18"Future Vision 8000k 50w bi-xenon projector HID's with 4300k 35w fog lightsLink to my build: Buildupdates/progress Link to comment Share on other sites More sharing options...
kickass audio Posted June 22, 2016 Author Report Share Posted June 22, 2016 Bump! Feel free to shoot me offers on the amp, sub or batteries. 2004 GMC Envoy1 XS power S3400 batt under the hood and 4 XS Power D3100's battery installed in the rear by the amps0 gauge power wire from front to backAlpine iva-w205 touchscreen dvd/cd/mp3/ipod/am/fm/gps headunitSundown Audio SAX-200.4 amp for my mids and highs8 gauge speaker wire from amp to woofer270 amp Mechman AltRockford Fosgate T1652-s component speakersRockford Fosgate 3Sixty.2 sound processorRca's from Rockford Fosgate and Monster Cable14 gauge speaker wire for the mids and highs1 18" Ascendant Audio SMD Dual 1 ohm with custom Black & Blue carbon fiber and hand signed dustcapBox: 5.66 cubic feet net volume box tuned to 30.13Hz with 1.5" wide wooden dowels and 1.5" thick baffle1 DC Audio 5.0k amp wired to .5 ohms nominal with an imp rise of 1.35 ohms for the single AA SMD 18"Future Vision 8000k 50w bi-xenon projector HID's with 4300k 35w fog lightsLink to my build: Buildupdates/progress Link to comment Share on other sites More sharing options...
kickass audio Posted June 23, 2016 Author Report Share Posted June 23, 2016 Bump, here are some more pics I took of the amplifier. 2004 GMC Envoy1 XS power S3400 batt under the hood and 4 XS Power D3100's battery installed in the rear by the amps0 gauge power wire from front to backAlpine iva-w205 touchscreen dvd/cd/mp3/ipod/am/fm/gps headunitSundown Audio SAX-200.4 amp for my mids and highs8 gauge speaker wire from amp to woofer270 amp Mechman AltRockford Fosgate T1652-s component speakersRockford Fosgate 3Sixty.2 sound processorRca's from Rockford Fosgate and Monster Cable14 gauge speaker wire for the mids and highs1 18" Ascendant Audio SMD Dual 1 ohm with custom Black & Blue carbon fiber and hand signed dustcapBox: 5.66 cubic feet net volume box tuned to 30.13Hz with 1.5" wide wooden dowels and 1.5" thick baffle1 DC Audio 5.0k amp wired to .5 ohms nominal with an imp rise of 1.35 ohms for the single AA SMD 18"Future Vision 8000k 50w bi-xenon projector HID's with 4300k 35w fog lightsLink to my build: Buildupdates/progress Link to comment Share on other sites More sharing options...
THEKINGsBACK Posted June 23, 2016 Report Share Posted June 23, 2016 Trades? he wouldnt be the first to say they did a 167 with a system like that (one that clearly DOESNT), but i have to say, he didnt beat me anywhere, ive never competed against the guy. If he thinks his does a 167, mine would probably put him in a coma. :hairtrick: Link to comment Share on other sites More sharing options...
kickass audio Posted June 23, 2016 Author Report Share Posted June 23, 2016 Trades? I don't know why I didn't list that, someone else pm'd me about a possible trade. I am looking for a decent 12" sub (no, not a kicker or any other garbage like that). If anyone had a decent 12" sub, maybe like a DC audio lvl3 12" with dual 2 ohm coils. I am looking to run my sub at 4 ohms on my old precision power pc2350 amp I have. 2004 GMC Envoy1 XS power S3400 batt under the hood and 4 XS Power D3100's battery installed in the rear by the amps0 gauge power wire from front to backAlpine iva-w205 touchscreen dvd/cd/mp3/ipod/am/fm/gps headunitSundown Audio SAX-200.4 amp for my mids and highs8 gauge speaker wire from amp to woofer270 amp Mechman AltRockford Fosgate T1652-s component speakersRockford Fosgate 3Sixty.2 sound processorRca's from Rockford Fosgate and Monster Cable14 gauge speaker wire for the mids and highs1 18" Ascendant Audio SMD Dual 1 ohm with custom Black & Blue carbon fiber and hand signed dustcapBox: 5.66 cubic feet net volume box tuned to 30.13Hz with 1.5" wide wooden dowels and 1.5" thick baffle1 DC Audio 5.0k amp wired to .5 ohms nominal with an imp rise of 1.35 ohms for the single AA SMD 18"Future Vision 8000k 50w bi-xenon projector HID's with 4300k 35w fog lightsLink to my build: Buildupdates/progress Link to comment Share on other sites More sharing options...
THEKINGsBACK Posted June 23, 2016 Report Share Posted June 23, 2016 Shoot me a pm let's chat he wouldnt be the first to say they did a 167 with a system like that (one that clearly DOESNT), but i have to say, he didnt beat me anywhere, ive never competed against the guy. If he thinks his does a 167, mine would probably put him in a coma. :hairtrick: Link to comment Share on other sites More sharing options...
kickass audio Posted June 24, 2016 Author Report Share Posted June 24, 2016 BUMP! let's get this stuff gone. price update: SMD 18 v1: $600 shipped DC Audio 5k: $800 shipped XS Power D3100's: $200 plus shipping each or $500 for all 3 plus shipping. edit: Sub is pending sale 2 batteries are pending sale 2004 GMC Envoy1 XS power S3400 batt under the hood and 4 XS Power D3100's battery installed in the rear by the amps0 gauge power wire from front to backAlpine iva-w205 touchscreen dvd/cd/mp3/ipod/am/fm/gps headunitSundown Audio SAX-200.4 amp for my mids and highs8 gauge speaker wire from amp to woofer270 amp Mechman AltRockford Fosgate T1652-s component speakersRockford Fosgate 3Sixty.2 sound processorRca's from Rockford Fosgate and Monster Cable14 gauge speaker wire for the mids and highs1 18" Ascendant Audio SMD Dual 1 ohm with custom Black & Blue carbon fiber and hand signed dustcapBox: 5.66 cubic feet net volume box tuned to 30.13Hz with 1.5" wide wooden dowels and 1.5" thick baffle1 DC Audio 5.0k amp wired to .5 ohms nominal with an imp rise of 1.35 ohms for the single AA SMD 18"Future Vision 8000k 50w bi-xenon projector HID's with 4300k 35w fog lightsLink to my build: Buildupdates/progress Link to comment Share on other sites More sharing options...
soundstream15 Posted June 25, 2016 Report Share Posted June 25, 2016 Would you trade for a mint soundqubed 4500? Not much of a down grade in power Link to comment Share on other sites More sharing options...
kickass audio Posted June 25, 2016 Author Report Share Posted June 25, 2016 I actually need a downgrade on the power of the amp. I don't actually need an amp though. I already am going to try and use my sundown sax 200.4 for the sub and if that doesn't work too well, my precision power pc2350 amp. The only trade I would consider for any of what I have for sale is a 12" sub that can be in a 1.5 cube or smaller ported enclosure and take roughly 1.5kw of power. 2004 GMC Envoy1 XS power S3400 batt under the hood and 4 XS Power D3100's battery installed in the rear by the amps0 gauge power wire from front to backAlpine iva-w205 touchscreen dvd/cd/mp3/ipod/am/fm/gps headunitSundown Audio SAX-200.4 amp for my mids and highs8 gauge speaker wire from amp to woofer270 amp Mechman AltRockford Fosgate T1652-s component speakersRockford Fosgate 3Sixty.2 sound processorRca's from Rockford Fosgate and Monster Cable14 gauge speaker wire for the mids and highs1 18" Ascendant Audio SMD Dual 1 ohm with custom Black & Blue carbon fiber and hand signed dustcapBox: 5.66 cubic feet net volume box tuned to 30.13Hz with 1.5" wide wooden dowels and 1.5" thick baffle1 DC Audio 5.0k amp wired to .5 ohms nominal with an imp rise of 1.35 ohms for the single AA SMD 18"Future Vision 8000k 50w bi-xenon projector HID's with 4300k 35w fog lightsLink to my build: Buildupdates/progress Link to comment Share on other sites More sharing options...
kickass audio Posted June 26, 2016 Author Report Share Posted June 26, 2016 Bump Sub is SOLD Batteries are pending offers. Amp is still for sale. $800 shipped anywhere in the cont. U.S. Possible trade ideas for the DC 5k, ONLY a 12" sub similar to a dc audio level 3 12" with either dual 1 or dual 4 ohm coils and can run in a 1-1.5 cube ported box. 2004 GMC Envoy1 XS power S3400 batt under the hood and 4 XS Power D3100's battery installed in the rear by the amps0 gauge power wire from front to backAlpine iva-w205 touchscreen dvd/cd/mp3/ipod/am/fm/gps headunitSundown Audio SAX-200.4 amp for my mids and highs8 gauge speaker wire from amp to woofer270 amp Mechman AltRockford Fosgate T1652-s component speakersRockford Fosgate 3Sixty.2 sound processorRca's from Rockford Fosgate and Monster Cable14 gauge speaker wire for the mids and highs1 18" Ascendant Audio SMD Dual 1 ohm with custom Black & Blue carbon fiber and hand signed dustcapBox: 5.66 cubic feet net volume box tuned to 30.13Hz with 1.5" wide wooden dowels and 1.5" thick baffle1 DC Audio 5.0k amp wired to .5 ohms nominal with an imp rise of 1.35 ohms for the single AA SMD 18"Future Vision 8000k 50w bi-xenon projector HID's with 4300k 35w fog lightsLink to my build: Buildupdates/progress Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.