Is This Too Much Power For My Subs?

SMD Forum: Is This Too Much Power For My Subs? - SMD Forum

Share Topic:

Page 1 of 1

You cannot start a new topic
Add Reply

Is This Too Much Power For My Subs?

#1 Crump

Advanced Member

Group: 18+ All Access!
Posts: 1,283
Joined: 17-November 08
Gender:Male
Location:Champaign IL

Posted 24 November 2008 - 11:53 PM

Will one Rf 1500 1Channel be too much for one 12" RF T1 2 ohm? Wired to one ohm? Or should i get 1 Rf 1500 1 channel for 2 12" Rf T1's?

Rebuild: http://www.stevemead...pic=48600&st=40

#2 Eric B

Advanced Member

Group: Super Moderator
Posts: 3,730
Joined: 25-February 07
Gender:Male
Location:Iowa

Posted 24 November 2008 - 11:54 PM

Either should work fine. But 2 12s for loudness

2006 Chevy HHR
UNDER CONSTRUCTION
4th Place Advanced 2 2009 MWSPL Finals
6th Place Xtreme 1 2009 MWSPL Finals

#3 Crump

Advanced Member

Group: 18+ All Access!
Posts: 1,283
Joined: 17-November 08
Gender:Male
Location:Champaign IL

Posted 25 November 2008 - 12:14 AM

Eric B, on Nov 25 2008, 12:54 AM, said:

Either should work fine. But 2 12s for loudness

well i was going to get two Rf 1500's One Per Sub OR 1 For 2 12's and which is better, Since the subs are dvc 2 Ohm, Should i wire to 1 ohm (1500 Watts) or 4 Ohms (500 Watts)

Rebuild: http://www.stevemead...pic=48600&st=40

#4 Eric B

Advanced Member

Group: Super Moderator
Posts: 3,730
Joined: 25-February 07
Gender:Male
Location:Iowa

Posted 25 November 2008 - 12:20 AM

Crump-T1, on Nov 25 2008, 01:14 AM, said:

well i was going to get two Rf 1500's One Per Sub OR 1 For 2 12's and which is better, Since the subs are dvc 2 Ohm, Should i wire to 1 ohm (1500 Watts) or 4 Ohms (500 Watts)

You dont 2 amps.. them T1s are only 600rms a single T-1500 is good enough to run 2 of them jus get 2 Dual 4 and wire that amp to 1ohm :good: