Jump to content

Thuginfc

Members
  • Posts

    54
  • Joined

  • Last visited

About Thuginfc

  • Birthday 07/28/1989

Profile Information

  • Gender
    Male

Thuginfc's Achievements

Newbie

Newbie (1/14)

13

Reputation

  1. Yes it was water cooled most people just loop the lines together when upgrading but I completely removed them
  2. Got the alt in. It doesn't charge at 15volts like the stock did but it definitely puts out some power. 14.5 volts steady at cruise and Only dropping to 13.5 idling at 600rpm. Full tilt. Now I'm ready to run my amps .5 ohm
  3. Finally got around to ordering. Gotta have it if I want bigger amps. Build log soon.
  4. I'll start a build log this weekend
  5. Yes that's what I'm looking to do. But maybe have the subs angled some. But I'd have to hav an "L" shaped box to get the airspace right. But then I could build a sick amp rack in the trunk.
  6. The rear seat doesn't fold. That's the reason I removed the rear deck. I've been trying to figure out if I should aim the subs and port up through where the deck was. Aim subs up where deck was and port through ski hole Aim subs at rear of seats and port up Aim subs at rear of seats and port through ski hole. Dunno what will be louder.
  7. The trunk/ car itself is sealed real good from any air leaks. Removed rear air outlet flapper ducts under the car and sealed with mdf inside and deadened. Deadened rear quarter panels and then foamed them full all the way to top of rear door. Trunk lid has two layers of deadener and also foamed full. (Weighs like 200+ pounds now) Trunk floor is deadens with two layers of deadener. Sides of trunk all the way into the cabin to rear doors deadened area under rear seats and rear floor boards deadned Working on deadining the whole car slowly and filling any voids that can't be deadneed with foam to help minimize the pressurized area a bit. Roof will also be stiffened with mdf. I'll start a build log soon.
  8. Not sealed off,yet. But the rear deck has been removed. wich helped get the air moving a lot. I do wanna re build the box and seal it from the lowest point of rear window. There's a big flat metal crossmember there. I like having my back seats especially since it's a Cadillac and my daughter likes to ride in my car rather than me using someone else's. Think it would be louder sealed off from there or leave it unsealed??
  9. Yes that 2 15s in trunk. Ported. Right now I've got em in a 7.75-8 cubes slot ported around 32 hz. Wanna try a little bigger with lower tuning see if I can get some decent hair tricks.
  10. Looking for a good box design for a pair of zvx 15s. I'm running them on a pair of hcca d5000s. I have about 17.5 inches height and about 50inches width. Depth I have atleast 50 maybe 60 inches. Really just need a good cubic foot trying to tune around 28-30hz Also considering sealing off the trunk.
  11. Okay thank you. Will be placing order this weekend. Wich voltage control module works with it??? And will I receive the charging system message on my dash??
  12. Just wondering if mech man makes an alternator for 2000 deville?? I know they have 2 diff versions of alternators. Well 3 if you include the water cooled. But one that has a 5 v signal from computer and one that takes 7v(?) from computer. I'd prolly end up with externally regulated but don't want that damn service charging system light on
×
×
  • Create New...