Jump to content

jonnylowkon

18+ All Access!
  • Posts

    719
  • Joined

  • Last visited

Posts posted by jonnylowkon

  1. I just ordered an x8 d2 for my 11 chevy Cruze. I've seen post where it's been said the sa8v2 (.75-1.0 cubes) will work but I'm running one off an saz1500v2 ( it's what I have to use since my zv3-12 is begging for more power so that's where my amp is coming from) and I want it to sound its best. But I have no wood working skills what so ever. So I'm looking for a good enclosure builder also in the Michigan northern Ohio area also. I'm a mechanic by trade. I listen to 50/50 hard rock and rap so I do like low but like my double pedal kick drum fills also... So what directions do I need to go? Mini 4th order like 1:1 ratio or labyrinth slot porting, or just a slot port box? And what should tuning be?

    Thanx in advance for any advice in the right direction! My guy Dave the box guy is out of box building now... Right at a yr from when I've got one of the best boxes I've ever had! Super bummed!!!!

  2. I have my sundown comps running with the crossover off a sax 100.4d and I have to say they sound great. Just wondering what they sound like active since I'm one of those people who can't leave things alone. I'd be using the crossovers on the amp, so does anyone have a recommendation where to set the crossovers? Or am I best off using a cc1. Any experience with how they sound active vs. passive would be great too.

    How many sets r u running off ur 100.4?

    I have the same amp and are about to run two sets

    Just wondering how u like them and where you have them placed at?

  3. So I finally got up enough money for 2 sets of SD sa 6.5's for my 100.4d .

    So should I just wire them up using the supplied crossovers using all four channels

    Or

    Use the crossover in the amp and use channels 1-2 for the 4 tweets

    And channels 3-4 for the 4 mid ranges?

    Would there be a noticeable gains by dropping down to 2 ohms and getting 160 per channel and being able to control the tweets level and the mids level separately ??

    Ill have to check and see what the mids and tweets actucally ohm out to be sure ..

  4. Ok so I have made room in the budget for 2 sets of the SD sa 6.5 component sets .

    So now my question is how much power do they like and would it be better to use the 100.4 crossovers or use the supplied crossovers that come with the components and just run them off each channel @100rms to each side?

    I was thinking since a lot of the dubstep music I've listen to goes from left to right and back to front and if I wired down to 2 ohms ( tweets off channel 1+2, and off the front preout set and the mids off channels 3+4, and off the rear preout sets) I would loose some of the stereo effect over running them off each channel separately ..

    Would the extra power be worth it of having each channel separate for the stereo imaging be better??

×
×
  • Create New...