Jeffl
Members-
Posts
54 -
Joined
-
Last visited
About Jeffl
Profile Information
-
Gender
Male
-
Location
The Dalles, OR
Jeffl's Achievements
Newbie (1/14)
2
Reputation
-
Tested in my house on first day and it plays just fine sounding so I doubt it's DOA, just the reading is throwing me off.
-
Yeah they play with power, but the amp would have nothing to do with the subs ohm readings.
-
-
Checked using that site and I have it wired "right" never had any issues with this ddm, check my other subs with it and it's spot on
-
Only running ~300rms to them until I figure this out, I don't want to have the wiring messed up and blow it before I can give them any real power. What sized box were using? Just curious
-
Got a new re audio srx 12 inch dual 2 ohm I wired it 4ohm but when I test my wires going to the amp it reads 6.8 ohms. I double checked the box and it states dual 2 ohm not the 4 ohm one. Anyone had this problem with the srx 12? Or any other sub? Did I just mess up the wiring or r they just high? Any thoughts?
-
planning on buying one of these next paycheck just wondering whats the cubes i need for a 28-30hz ported box for a single vvx 12. round port or slot opinions welcome too just for a daily driver no spl contests i have a mb quartz onyx 1500.1d amp.
-
Looking for a new sub since mine got stolen last night.. I have a Mb quart onyx 1.1500d amp. Not looking to do spl contests but would like to b punched in the back on double bass songs. Size doesn't matter (even though it'll probably end up being a 12). But open to all sugguestions.
-
bought a cheap spl from sonicelectrionics http://www.sonicelectronix.com/item_33985_Scosche-SPL1000F-SPLMETER.html .it peaks at 103db at half volume and wont get any higher sitting in the drivers seat. the closer to the front speakers i get the higher it goes up to 131+db it says but nothing higher when i take it closer to my sub. so is my meter just shitty and isnt picking up my music correctly? or am i really only hitting 103db at the drivers seat?
-
I get 2v pre outs at 50/50 volume and then 1v at 44/50 then it goes to .3v at 35/50 volume, I have no way to tell at what point my hu clips at do I set it to 75% max volume 35.
-
Instead of the 2.5v I thought I was sending to the amp
-
Well found out at my 75% max volume my rcas where only putting out .3 volts, so retuned my amps knowing that's how much voltage there getting and my sub is 20x louder and cleaner.
-
When I set my subs gain I had the subwoofer setting at +08 which is max. Also have a rf punch control which is a gain knob (yes I have tested this) but even at my full gain I don't get any sub response until about 25% (10-40)of my max clean head unit volume