Search the Community
Showing results for tags 'tune'.
Found 3 results
-
I just bought a 1500rms American Bass XFL1222 and built a box for it. For the longest time I was listening to my friends sub which is a 800rms Skar Audio SVR-12 and it’s always at full volume. On the amp for the skar sub it measures 23V and on the amp for the American bass sub i set the gain to around 23V for break in which is around 750-800W (arround half of 1500RMS). I assume since both amps are outputting the same voltage to the subs they should be the same loudness. But no. Then American bass sub is not nearly as loud as the skar audio sub at 23V. is this because the sub is rated for higher rms so it is not outputting the same as the skar sub, even tho they r both at 23V but the American bass is only pushing half the recommended power? please leave your suggestions or comments. thanks -
Currently I am setting my gains on my d-4.800 and I am noticing something I have never seen before. First I use the dd1 on my head unit and I get max hu value of 39 of 40 When I go to the dsp on the d-4.800 I leave the input at 0db. If I go over this the max input light on the d-4.800 lights up. When I try to set the output gains at HU volume of 39 using the 1khz -5db it allows me to set the gain all the way up with no distortion. I think I am doing something wrong. I have used the dd1 before with my 360 and never had this issue. Any advice would be greatly appreciated. Thanks Bret
-
Being new to car audio, i don't understand what "gain overlap" really means, -10db, -5db, 0db ? What is the best way to tune my system with my DD-1? And what settings should i set all my dials in the amp? This is my first time using this and I don't want to misunderstand steps from the manual. 2sundowns U12 D4 wired at 1ohm Skar rp4500 amp LC2I ACR1 (bass knob) for LC2I
