Jump to content
Sundown Audio

Your first amplifier - what was it?


meade916

Recommended Posts

My first amp (about 15 years ago), was a Pyramid PB448, the white one with purple fins. Had this on two old school RF Punch 12's in a sealed prefab and thought I was just the cats meow LOL. I can remember my first slight trunk flex and everyone in my neighborhood awwing at it haha! Good times, before I broke my wallet for this passion :/

Head Unit - Clarion VX709 7" DVD Touchscreen

Mid/Highs - Front Doors - RF Prime 6.5" component mids.

A. Pillars - RF Punch component tweets.
B. Pillars - RF Prime component tweets.
Rear Doors - RF Punch 5.25" mids.
RF Punch 3-way passive X-overs.
Mid/Highs Amp - MB Quart Onyx 360.4, 4 channel, 640W RMS.
Subs - (2) PowerBass 3XL 15, 1000w RMS, 3" flat wound coil, 562oz motor, 10" spider.
Sub Amp - Audiopipe GD6001 @.5ohm, clamped 2825RMS.
Box - 9.6 cu^3 net @35Hz, three 6" aero's.
Charging - Energizer 120Ah AGM under the hood, MaxLife 75Ah in the rear. Big 3, 140A aftermarket alt. (off brand)
Wires - Two JL Audio 2/0ga OFC. runs to rear, 4ga. power/2ga. ground to component amp (OFC), 1/0ga. OFC Knu Konceptz Kolossus Kandy everywhere else.
Link to comment
Share on other sites

my first amp was the one of the old vr3 200 watt 2 channels you could buy at walmart. the ones with the clear casing on top and the red finned heat sinks. had it pushing a pair of roadmaster 6.5's in my very first vehicle. 1974 ford courier.

LOL, my neighbor still uses two of them on two older Kenwood Excelon 12's.

  • Like (+1 Rep) 1

Head Unit - Clarion VX709 7" DVD Touchscreen

Mid/Highs - Front Doors - RF Prime 6.5" component mids.

A. Pillars - RF Punch component tweets.
B. Pillars - RF Prime component tweets.
Rear Doors - RF Punch 5.25" mids.
RF Punch 3-way passive X-overs.
Mid/Highs Amp - MB Quart Onyx 360.4, 4 channel, 640W RMS.
Subs - (2) PowerBass 3XL 15, 1000w RMS, 3" flat wound coil, 562oz motor, 10" spider.
Sub Amp - Audiopipe GD6001 @.5ohm, clamped 2825RMS.
Box - 9.6 cu^3 net @35Hz, three 6" aero's.
Charging - Energizer 120Ah AGM under the hood, MaxLife 75Ah in the rear. Big 3, 140A aftermarket alt. (off brand)
Wires - Two JL Audio 2/0ga OFC. runs to rear, 4ga. power/2ga. ground to component amp (OFC), 1/0ga. OFC Knu Konceptz Kolossus Kandy everywhere else.
Link to comment
Share on other sites

Sparkomatic 20 watt power booster. Ran 3-80 Chevy alternators to power that beast . Hung from my dash. Lol!

http://www.stevemeadedesigns.com/board/garage/vehicle/2438-jeep-commander/


th_140x100square.jpgMechman_140x100px.JPGDCHome.jpgI

image_url-76414-1423274612_thumb.jpgimage_url-76414-1423320284_thumb.jpg

Pioneer P99RS
Ampere 3800
2-Ampere 125/4
4-6.5 inch Hertz HSK XL Mids
4-8 inch JL Audio ZR Midwoofer

2-5.25 Satori Mids
2-Morel Tweeters, 2 Hertz Milles 3 inch on A pillars
2-Hertz Silk tweeters
DC Audio Level 5/12
Skyhigh Wire
Mechman 320
XS Power D3100

MO Funniest Thread of the Year 2013: http://www.stevemead...dy-being-a-pos/

Link to comment
Share on other sites

  • 1 year later...

A Bazooka ELA500.1 and a rockford fosgate punch 2 channel(to this day havent been able to identify it!!) were the first two amps i ever played around with, with some cheezy kicker comp 10s and then one day my dad gave me one of the OLD kicker cvr's, (before the crazy looking cones, when the cone was just a uniform cup). when i hooked it up the first vs a single 10 it seemed quieter than the 10... that was the day i learned about the effects of varying impedance loads on amplifiers

Link to comment
Share on other sites

Rockford Fosgate 200IX

2007 Chevy Tahoe (SOLD)

12 ~ FI Audio X series 10" w/BP option

2 ~ DC Audio 5.0K @0.67

3 ~ DC Audio 5.0K @1.0 

2 ~ PPI 3 way sets (not installed yet)

1 ~ RF T400-4, 1 ~ RF T600-2, 1 ~ RF T600-4

4 ~ CT Sounds 5.25" Strato comps  (rear fill only)

1 ~ XS Power D4800

1 ~ XS Power D3400

8 ~ XS Power XP3000

160 stock alt, Mechman 370 Elite, 185 DC Power

320+ Sq. Ft. Sound Deadener

Pioneer AVH-X5500BHS

Youtube: https://www.youtube.com/user/knfjdkghjudfhsgkjdhf/videos?sort=dd&view=0&shelf_id=0

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 186 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...