Jump to content
Sonic Electronix

blew my amp could it be from power distribution box?


Recommended Posts

I highly doubt the distro is the issue, I would do a run of 0ga - and + to the rear batts pulling that much power,

are you running too low of an ohm load? I've seen a few RF amps have issues going below 1ohm. check your pre outs too

Link to comment
Share on other sites

  • Replies 28
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Can you post a pic of the front battery with the wires connected to it? I want to see the terminals and such...

i dont have a pic of that.. i got pissed and tore everything out right away. all it was, was a normal front to back battery setup. fuse was 18 inches away from front battery, and 18 inches away from back battery.. 0 guage ring terminals as connectors sotered on..

My youtube channel, please subscribe
http://www.youtube.com/ballinblaza

Link to comment
Share on other sites

I dont see where your back cable is hooking to the front. If you connected it to that little dinky terminal that would be a big mistake........ If you hooked your wire up through the dist. box then it would have been a bigger mistake. Not doing the big three could have been very helpful as well......

that dinky terminal isnt actually that small, it worked great, and the big 3 has nothing to do with it, when my system did play at full tilt, i only dropped from 14v to like 13.5v at Idle

Edited by homiewes

My youtube channel, please subscribe
http://www.youtube.com/ballinblaza

Link to comment
Share on other sites

I highly doubt the distro is the issue, I would do a run of 0ga - and + to the rear batts pulling that much power,

are you running too low of an ohm load? I've seen a few RF amps have issues going below 1ohm. check your pre outs too

i would have ran a run to the (-) from front to back but i ran outta wire. and at first i was running a 1ohm load, and i eventually wired it to 4 ohms and the problem still existed..

My youtube channel, please subscribe
http://www.youtube.com/ballinblaza

Link to comment
Share on other sites

Def should have done the big three. Gotta have proper wire to deliver the amperage that the amp needs to function. Did the amp get hot at all?

i never really got to play it long enough to even check if the amp got hot

My youtube channel, please subscribe
http://www.youtube.com/ballinblaza

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 344 Guests (See full list)

    • There are no registered users currently online



×
×
  • Create New...