Dorm room Crescendo help

[LUV bass]

Ok, I want to use 4 Crescendo mp6's and 2 xst2s Super tweets in my college dorm room. These will likely be going in my truck when I get out of college.

I was looking at this amp to power them (but am open to suggestions) :

http://www.parts-exp...310-304&scqty=1

The 6's come in either 4 or 8 ohm, and the tweets only in 8. So my question is, should I get all in 8 ohm, and wire them like so;

or get the mids in 4 ohm, and wire them like so to two of the channels, then wire the 8 ohm tweets to the other two channels?

Also, should I band-pass the mids? If so, what would be the best way to do this? And for the high-pass for the tweets, can I just use something like this: http://www.parts-exp...tnumber=266-474 ?

I am open to any and all suggestions/opinions

Thanks for any help, and if I left out any information, please ask.

Edited February 18, 2012 by LUV bass

[Tebo]

Those super tweeters are going to be fucking retarded loud in your dorm your ears are Guna bleed lol. Super tweeters are supposed to used make your highs come in clear over high split levels. Try some part express for some home audio tweets. Morel and dayton are some names you should look for

[SmallTruk]

I'd do the two 4ohm setup, it'll make things easier in multiple ways.

I'd skip the super tweets too. If you want some cheap, decent tweets my fav is the Vifa XT25's. MadiSound, Amazon and Parts Express all sell them. Usually about $28-35 a piece.

[412 CVX]

what's the minimum impedance of that amp?

[Kranny]

12v 4 amp power supply. thats 48 watts, max. so like 10w a channel. you'd be better off using a freaking headunit than that p.o.s

[LUV bass]

Ok, I'll look into some other tweeters, and I belive the minimum impedance of the amp is 2ohm/channel

[LUV bass]

http://www.parts-express.com/pe/showdetl.cfm?Partnumber=275-070

How about these?

And Kranny, what kind of alternative would you suggest? I don't need crap loads of power, it's a small room, lol

[412 CVX]

Look into a cheap, stereo receiver. it'll be 8 ohm stable but better

[Kranny]

Look into a cheap, stereo receiver. it'll be 8 ohm stable but better

x2 this

[LUV bass]

So about the stereo receiver, could I get the 4 ohm mids, wire each pair to 8 ohms? Then how would I go about wiring in the tweeters (Also 8 ohm)?