Jump to content

DC 3.5k on a level 2 10" time to build a new box finally


Recommended Posts

My dc 3.5k came in a few weeks ago :)

8A845393-4731-4CA8-B2CB-196DDEC72E64-3841-000006C22BAD7912.jpg

2CFDB255-4AA9-4D15-9C97-9B1542FFE154-3841-000006C2239C09CC.jpg

My old Hifonics next to the dc

0B1EB205-144C-48D5-86F7-63A7BF15D7A9-3841-000006C26B57820A.jpg

I had to install it

A0324A19-046D-4BC1-8419-0A16F60423C8-3841-000006C215553323.jpg

I did notice a sound difference and a bit louder than hfi even tough I think their ratings are the same at 2ohm and I feel like it's less hungry for power than the hfi

But theres no point of it being install its currently wire at 2ohms tune with the 0db track with the dd-1.

Not sure if I'll switch back until I get the electrical to par all I know my lights don't dim even if I have the heater on at night the gain is really low

Link to comment
Share on other sites

  • Replies 67
  • Created
  • Last Reply
  • 1 month later...

Time for a new box

Plexiglas for the 3.5k to show the guts

And yes a dc3.5k to a level 2 10 it will be wire at 4 ohms which the sub is rated at 600 watts and the amp at 750 I believe so it'll be a Goid match it'll give time to upgrade my electrical to run it at 1 ohm with 4 level 2

Link to comment
Share on other sites

  • 2 weeks later...

crunch 4 channel amp i dont really like it but it gets the job done so i dont camplain

IMG_1255.jpg

If you added a cover to that amp/fuse holder to cover the wires and terminals, it would look 10 times better! And wouldn't cost much

2010 HHR LT - DNX 6160 - sony xec-700 - sony xm-4040 for door mids - XM-6020 for tweets in a-pillar - saz1500d v1 - VVME RD-12 1.75 f^3 32hz

guru and president of the "cheap asses trying to beat up the block with bargain bin woofers" club

Link to comment
Share on other sites

crunch 4 channel amp i dont really like it but it gets the job done so i dont camplain

IMG_1255.jpg

If you added a cover to that amp/fuse holder to cover the wires and terminals, it would look 10 times better! And wouldn't cost much

I did make one but the way I had it didn't fit I guess I didn't think on it to much cause I just had an idea right now on how to doit

But it's all coming out haven't done anything cause

I've been thinking a way to make it look better not just throw it in their like this one

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 291 Guests (See full list)

    • There are no registered users currently online



×
×
  • Create New...