tlh_360 Posted June 30, 2012 Author Report Share Posted June 30, 2012 Ya I noticed on that I used 16" not 16.25" that I needed, so technically its all wrong. But yes in that mock up is 16 in depth not 16.25 that I need. I was building the box and noticed it. But yes now I have come up with the correct 14 and 22. I will be posting yet another box design shortly. lol. That is why I love SMD. You learn so much. Thanks. Quote Link to comment Share on other sites More sharing options...
tlh_360 Posted June 30, 2012 Author Report Share Posted June 30, 2012 Hey what do ya know with the proper depth and using the center of the port I came up with center 14" and 22" and for the wood pieces 11" and 19 3/4". Thanks a lot. Finished box coming up soon! Quote Link to comment Share on other sites More sharing options...
tlh_360 Posted June 30, 2012 Author Report Share Posted June 30, 2012 (edited) If I add this 45 will it change anything? EDIT: The 45 in the port Edited June 30, 2012 by tlh_360 Quote Link to comment Share on other sites More sharing options...
Joe X Posted June 30, 2012 Report Share Posted June 30, 2012 There will be a small difference that you don't need to be concerned about. BUT it is very important that the 45 does not narrow the port below 3". It's also important to round or slant the inner corner, Take a look: Quote Link to comment Share on other sites More sharing options...
tlh_360 Posted June 30, 2012 Author Report Share Posted June 30, 2012 (edited) Yup had the rounded but did have to make the 45 a tad smaller. It was like 2 53/64. now its 3 5/32 so should have nice flow. The 45 is 1.75" in width if that matters. Edited June 30, 2012 by tlh_360 Quote Link to comment Share on other sites More sharing options...
Joe X Posted June 30, 2012 Report Share Posted June 30, 2012 That turn looks good! guess it's time to build. Quote Link to comment Share on other sites More sharing options...
tlh_360 Posted June 30, 2012 Author Report Share Posted June 30, 2012 Yup! Gonna try for this weekend/into next week. I will defiantly do a build log for it. Again . Quote Link to comment Share on other sites More sharing options...
tlh_360 Posted June 30, 2012 Author Report Share Posted June 30, 2012 The final drawing Quote Link to comment Share on other sites More sharing options...
Joe X Posted June 30, 2012 Report Share Posted June 30, 2012 Looks neat, get your cuts really straight for a simple and solid build. Quote Link to comment Share on other sites More sharing options...
Decaf Posted June 30, 2012 Report Share Posted June 30, 2012 (edited) funny that people are more concerned with top to bottom brace but neglect to brace the 32" wide back panel that is very prone to flexing i would add a dowel the width of the port centered to back panel centered to height to keep that panel stiff, and it will stiffen that long port wall better as well my ZV3 is in 3.5cuft@32hz with 50sqin and its pretty ridiculous for a single 15" on a crescendo3500@1ohm If I were to rebuild my box I would go down to 3.25cuft, raise tuning to 33/34 and leave port area the same Edited June 30, 2012 by Decaf Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.