Got my new car. Now how to get my subs in...

[BobbyG2]

It's 15.5" at the trunk opening to cabin, it's 16-17" lowest until than I think I might do the 36" deep, but than it'd be a tight squeeze with only 36" wide getting the port and subs on the same face Should be able to fit two 6" pvp pipes, but not sure if that's enough port area. Maybe port through rear deck somehow?

I'll end up with 7.21 in2 ft3, 56.52 in2 total port area, with two 6" ports

Edited August 14, 2012 by BobbyG2

[Dillan Turvold]

i'd do 36" width and 15" height.

you have to remember to take into account the trunk opening itself.

build a couple boxes out of cut cardboard to see if itll fit in there.

I build a large dual 2.1 cu.ft. 12" sub box and I couldn't quite fit it through the trunk opening, so I took the top of the back seats off and slid it in through the front, maybe u could do the same?

-nvm I didn't look closely enough at ur measurements my bad~

Edited August 14, 2012 by Dillan Turvold

[NT_Hardcore]

just build it in the trunk

[BobbyG2]

^ I would consider it, but my rear seat doesn't even fold down lol

Not even a ski hole... Lol

I'll grab some cardboard and experiment with boxes and see what I can find to fit with the most amount of airspace.

It'll probably end up looking funky, but anything for that extra airspace! Lol

Edited August 14, 2012 by BobbyG2

[Dillan Turvold]

If you're going to build it inside the trunk and air space is a huge issue for you, you could build a box which conforms to the trunk itself w/ a port facing forward.. just an idea