UMGixxer Posted December 12, 2012 Report Share Posted December 12, 2012 Them some fiberglassing fools down there lol Link to comment Share on other sites More sharing options...
ThreehundredC Posted December 12, 2012 Author Report Share Posted December 12, 2012 would that hifonics 2000.4. says brigable 1000w could this amp run subs or just highs Link to comment Share on other sites More sharing options...
UMGixxer Posted December 12, 2012 Report Share Posted December 12, 2012 could run both but it only runs 1000x bridged @ 4 ohms Link to comment Share on other sites More sharing options...
ThreehundredC Posted December 12, 2012 Author Report Share Posted December 12, 2012 ..so i have a L715 dual4 on kicker 750.1 @2ohm. would that be an upgrade. ? Link to comment Share on other sites More sharing options...
UMGixxer Posted December 13, 2012 Report Share Posted December 13, 2012 yeah you could bridge it and run each coil on each channel, that would be 2000w to that sub tho, just back the gain down Link to comment Share on other sites More sharing options...
ThreehundredC Posted December 13, 2012 Author Report Share Posted December 13, 2012 ..oh reaaly. might have to jam 2000 to the kicker for the carshow this weekend until i get my highs Link to comment Share on other sites More sharing options...
ThreehundredC Posted December 13, 2012 Author Report Share Posted December 13, 2012 so do i connect positive to positive on the sub or just bring eachside to the amp seperate Link to comment Share on other sites More sharing options...
UMGixxer Posted December 13, 2012 Report Share Posted December 13, 2012 Do not connect the coils on the subs together, just take the + & - from each coil to the bridged + & - on the amp, probably something like the - on channel 1 and the + on channel 2 and do the same for channels 3 & 4. Link to comment Share on other sites More sharing options...
ThreehundredC Posted December 13, 2012 Author Report Share Posted December 13, 2012 another question. i have 8gauge wire n fuse n ground.. the amp says it can fit a 4gauge which im guessing ill need. can i just cut the 8 inhalf and run then together as a bigger wire Link to comment Share on other sites More sharing options...
UMGixxer Posted December 13, 2012 Report Share Posted December 13, 2012 Are you talking about cutting the rubber off of the wire and putting them together? I would just run 2 runs of the 8 ga into the amp, so you would have to sections of power and two sections of ground a total of 4 - 8 ga wires running into the amp. It will work but go ahead and get some 4 ga when you can. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.