ThreehundredC Posted May 10, 2013 Author Report Share Posted May 10, 2013 so my doors have been laying on the ground for a week and nothing got finished or anything worth keeping so now im back to square one this is hard stuff Link to comment Share on other sites More sharing options...
ThreehundredC Posted May 11, 2013 Author Report Share Posted May 11, 2013 still stuck with a crappy door panel never got done idk how to go about it on these "easy" doors Link to comment Share on other sites More sharing options...
EpicenterDesigns Posted May 14, 2013 Report Share Posted May 14, 2013 Easy answer? Send them to me Building The Best.....Repairing The Rest The bitter after-taste of a poor quality job will last far longer than the sweetness of that cheap price! Link to comment Share on other sites More sharing options...
b-eazy Posted May 14, 2013 Report Share Posted May 14, 2013 Right choice...send them to epicenterdesigns. ..lol...love his work. ....got mikeys hummer doors...and the hummer. .....bwahhhhhahhhh lol...... Link to comment Share on other sites More sharing options...
ThreehundredC Posted May 14, 2013 Author Report Share Posted May 14, 2013 well since i am not employed i cannot afford to spend up to a thousand for full installs wish i could Link to comment Share on other sites More sharing options...
ThreehundredC Posted May 14, 2013 Author Report Share Posted May 14, 2013 i put the rings on the door and then made a cover plate with bendable plywood so it could bend down to the edges and screwed it down normally you could router out a thing piece and make like a wall then have another board on top and body fill the sides to a nice curve but i dont have a router to make that thin strip around as a frame t build up so the 8 still needs some lift to fit it will be wrapped in gator just sprayed the edges just incase it shows Link to comment Share on other sites More sharing options...
ThreehundredC Posted May 14, 2013 Author Report Share Posted May 14, 2013 pull it out trim it even at edges light sand then glue the marterial to it Link to comment Share on other sites More sharing options...
b-eazy Posted May 14, 2013 Report Share Posted May 14, 2013 Good start. .. Link to comment Share on other sites More sharing options...
ThreehundredC Posted May 14, 2013 Author Report Share Posted May 14, 2013 its something.. just gotta figure out how to get that angle on the speaker it hits the metal of the door and the tweeter could been an inch or so higher but ill see how it does when i get some glue for the wrap Link to comment Share on other sites More sharing options...
ThreehundredC Posted May 15, 2013 Author Report Share Posted May 15, 2013 will do some more tomorrow Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.