sbg Posted July 31, 2014 Report Share Posted July 31, 2014 Had my hands on a lot of audio pipe amps and you sir don't know a good amo until you run one. When you have a audio pip, its like "man its a good amp" then 4 months down the road you buy a good amp and your like... Fuck that audio pipe was junk lolexactly how i was when i switched from the ap1500 to an aq 1200 lol I have ran them all, hifonic, belva, audio pipe, pure and so on and they all don't stack up and the end of the day. 01 focus se 110 amp alt Big 3 sky high and stinger hpm ofc 1/0 Super start platinum AGM (starting) 2 runs of 1/0 Execution audio front to back Kenwood double DIN DDx271 A pillars- orion 4" super tweeter and 2-1" alpines. Orion xtx 64 in the front doors 2:1 4th order bandpass Sealed off trunk Digital designs deadener on roof/ rear deck Orion hcca 12s (black coils) Orion xtr3700.1 Orion xtr250.2 mid/highs All sky high 1/0 in trunk dual runs(power/ground) Sky high dual 1/0 inputs 2 xs power D3100 in back Sky high batt blocks Rose audio batt blocks Stinger volt meter All sky high 1\0 fuse and holders Db link remote/ rca Link to comment Share on other sites More sharing options...
poorfish88 Posted July 31, 2014 Report Share Posted July 31, 2014 I do not run this amp, Simply just posted here since its no where else on the net, Clamped it today tho, And its doing 1804 @ 14.2 volts so not bad, but not the best. how did you tune the amp I just simply Clamped it, the owner had everything else set already. the test is void then if nobody knows if the amp was clipping or not. in general According to Clip light on bass knob, it was not clipping, Also test was done on 41hz tone. Clip light on a bass knob to show clipping.....FAIL....God only know what else was screwed up in this shitty non valid test . Link to comment Share on other sites More sharing options...
audiofanaticz Posted August 1, 2014 Report Share Posted August 1, 2014 Original poster wants this thread deleted... He dont like the replies he got on his amp that was good for the money... I guess I will just lock it so people can reference this thread. Link to comment Share on other sites More sharing options...
OrionStang Posted August 1, 2014 Report Share Posted August 1, 2014 LOL SMD Super Seller My Feedback Thread Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.