Noobtastic14 Posted August 1, 2015 Author Report Share Posted August 1, 2015 It works great at shows because I bump on the temp while demoing and raise up the temp- then switch on the cooling and it drops at roughly 2 degrees per minute until I want to demo again. I leave it off while actually demoing because its another ~7A of draw that I just don't need when the alt is trying to put out power at ~180*F operating temp(case). -Drew I am a United States Military Arts and Crafts Professional. Sand it off, Paint it on. uhoh_45 said: dont be a pussy P give the jeep to drew Link to comment Share on other sites More sharing options...
Noobtastic14 Posted August 28, 2015 Author Report Share Posted August 28, 2015 This has been a week of maintenance on the car. In September I'm moving to Phoenix and want to make the beater a little more road worthy. It's got all new shocks and stiff rear Springs (too stiff! They're getting trimmed) And I've had horrible body roll for as long as I can remember. I've replaced the worn front sway bar bushings and installed a rear sway bar from an Integra gsr I'll add more photos when the vented brembo rotors and ceramic pads get in. -Drew I am a United States Military Arts and Crafts Professional. Sand it off, Paint it on. uhoh_45 said: dont be a pussy P give the jeep to drew Link to comment Share on other sites More sharing options...
Noobtastic14 Posted August 30, 2015 Author Report Share Posted August 30, 2015 The new ceramic pads get in tomorrow! -Drew I am a United States Military Arts and Crafts Professional. Sand it off, Paint it on. uhoh_45 said: dont be a pussy P give the jeep to drew Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.