bcbrassard Posted March 19, 2018 Report Share Posted March 19, 2018 What happened? Link to comment Share on other sites More sharing options...
Krupske Posted March 19, 2018 Author Report Share Posted March 19, 2018 5 hours ago, bcbrassard said: What happened? I needed the engine for this; I have that car for almost 5years now so thought it was time to put an engine in.. Plus the Golf mk3 was shit, rust and water leaks everywhere Link to comment Share on other sites More sharing options...
bcbrassard Posted March 19, 2018 Report Share Posted March 19, 2018 Any plans for a system in this ride? Link to comment Share on other sites More sharing options...
Krupske Posted March 19, 2018 Author Report Share Posted March 19, 2018 13 minutes ago, bcbrassard said: Any plans for a system in this ride? No not yet, maybe after i finish the blue 2 door-ed one.. Link to comment Share on other sites More sharing options...
Krupske Posted April 28, 2018 Author Report Share Posted April 28, 2018 So the problem with the engine is fixed, only too almost a year ? But the engine bay is complete now Looked like this before Painted and replaced a lot of stuff, while i was at it did the big 3 And the plans for the audio changed a bit.. again...? The new plan(setup) will be as following: HU: Pioneer MVH-X560BT Sub: Rockford Fosgate Power T0D215 Sub Amp: Rockford Fosgate Power T2500.1 Mids and Highs: Rockford Fosgate Punch P1652-S Components Mids and Highs Amp: Rockford Fosgate Punch P200.2 Electrical:Ground Zero GZBP 12.3500X battery Stock 90 Amp Alternator CCA 0 awg power/ground/big 3 CCA 8 awg subwoofer wire CCA 12 awg speaker wire Hollywood Energetic RCA's Hollywood Energetic Fuses and fuseholders Rockford Fosgate PEQ remote controller The Punch components, if they're not loud enough for with the T0 15 i will upgrade to T2 components and T400.2 amp Link to comment Share on other sites More sharing options...
Krupske Posted April 28, 2018 Author Report Share Posted April 28, 2018 Built the box, don't judge me i'm an amateur ? And mounted the amps Used these on every wire Link to comment Share on other sites More sharing options...
Krupske Posted April 28, 2018 Author Report Share Posted April 28, 2018 Trying to set the amps temporarily, until i bring it to a shop (i'm a noob) The T2500 is set at 40hz and the gain at 3 And the P200 at 70hz all pass and the gain at 6 Will this be ok/safe until i bring it to a shop to tune? Thanks ! Link to comment Share on other sites More sharing options...
reedal Posted May 1, 2018 Report Share Posted May 1, 2018 if you're waiting for a shop to tune, I would go ahead and leave the gain at 0 on both. as for the T2500 being set at 40hz, is that for the LPF or HPF? I'm assuming LPF, in which case, I would say no lower than 80, unless your mids can play 80hz well SMD Tool Map https://www.stevemeadedesigns.com/board/topic/193176-smd-tool-map-new-november-2014/ Build log https://www.stevemeadedesigns.com/board/topic/197217-reeds-03-tahoe-hat-sqaq-singer-xs-shca-cockbox-80prs/?page=32 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.