Jump to content

Crossover settings on AMP for sealed enclosure.


Dragonware

Recommended Posts

Recently downgraded from 4 cubes ported tuned to 32hz  with dual 12 RE audio subs. To 2 cubes sealed. My amp was set Low pass at 35hz and sub sonic to 15hz.

 

My question is my new setup is a sealed enclosure 2 cubes same subs. do I need to adjust my cross over settings on the amp now ?

 

I have an epicenter which can mimic the bass that i use to get with the ported  its still not as loud and I know its not an ideal situation but what would be the best settings im using a Hifonics Brx 2000.1D

My Build log :

http://www.stevemeadedesigns.com/board/topic/170934-dragonmobile-re-audio-2300rms-stealth-build-08-focus/

Current System

2020 Ford F-150 XLT Supercrew

Audio Control Epicenter

Audio Control LC7i

Taramp PRO 2.6 DSP

Taramp DS4x800 - Highs

Taramp HD3000.1  Mids

Taramp MD5000.1 Bass

8 x DS18 6.5 Pro x6m - mids 

2 x Soundsteam SST-05 Bullet Tweeter

2 x DS18 TW220 Super Tweeters

4 X SkarAudio EVL-8  BASS

Big 3 

Yellow Top

Link to comment
Share on other sites

And a infrasonic set at 15hz is useless  Especially tuned at 32hz.  But, if it sound good to you, have at it. I suggest doing the same thing on the sealed enclosure your now running. Set where it sounds good to you. 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   1 Member, 0 Anonymous, 346 Guests (See full list)

×
×
  • Create New...