Joshdashef Posted April 25, 2018 Report Share Posted April 25, 2018 With my previous amp, R750-1D, the wiring was wired in parallel internally and had two sets of speaker outputs (+ and -). Currently I have two 4 ohm dual voice coil subs each wired down to 2 ohms, and put into each of the pairs. Here is the wiring diagram for my current amplifier: Link for full PDF My question is with the upgraded amplifier I will be using, a DC 2k, do I need to follow this same routine and wire two sets of 2 ohm and it is internally paralleled. SMD Tool Map (2022): https://www.stevemeadedesigns.com/board/topic/220267-smd-tool-map-2022/ My Port Size Calculator (in progress): https://www.stevemeadedesigns.com/board/topic/217087-port-size-calculator-in-progress/ Common Port Walls for a Slot Port: https://www.stevemeadedesigns.com/board/topic/217076-common-port-walls-why-it-matters-to-your-box/?tab=comments#comment-3240313 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.