DiBo Posted February 14, 2019 Report Share Posted February 14, 2019 About to run to Curtis steel here in Las Vegas Nevada. Does anybody have any advice for making some distribution bars out of aluminum stock? Link to comment Share on other sites More sharing options...
k58.cross Posted February 14, 2019 Report Share Posted February 14, 2019 No experience, let us know how it goes man. I did read though that aluminum conductors should be sized two AWG higher than copper for the same amount of current. How that equates to a rectangular bus bar I dunno. Link to comment Share on other sites More sharing options...
DiBo Posted February 14, 2019 Author Report Share Posted February 14, 2019 1 hour ago, k58.cross said: No experience, let us know how it goes man. I did read though that aluminum conductors should be sized two AWG higher than copper for the same amount of current. How that equates to a rectangular bus bar I dunno. I was just going to grab some quarter inch aluminum flat stock it's only $20 for a 12 ft long piece. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.