Stephen Dunnington Posted March 2, 2019 Report Share Posted March 2, 2019 Positive and ground wire ripped out of my SMD VM-1. What type of solder should i use to get them bsck in? Also is there an electrical putty i can use to seal them to avoid them pulling out again? I've never welded any type of board so not sure what exactly i need to do. Link to comment Share on other sites More sharing options...
CstrokerV Posted March 10, 2019 Report Share Posted March 10, 2019 Any electrical solder will work and how did they get pulled out ??? I would zip tie or hot glue the wires to something so they don’t move around... my build http://www.stevemeadedesigns.com/board/topic/142505-small-build-log-4-dc-lvl3-10s-tl-update-link-to-rebuild/ http://www.stevemeadedesigns.com/board/topic/154258-rebuild-6-lvl3-12s-update-small-video-nothing-spectacular/ new build http://www.stevemeadedesigns.com/board/topic/188181-03-trailblazer-slow-build-8-dc-lvl3-12-m1-motor-m2-parts/ Link to comment Share on other sites More sharing options...
Kyblack76 Posted March 10, 2019 Report Share Posted March 10, 2019 Over thinking. Any core type that sticks. Done..... SMD SUPER SELLER The Burban Build Blazer Build sold Acura trunk build sold Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.