edgil1985 Posted April 11, 2019 Author Report Share Posted April 11, 2019 I don’t have access to any SMD devices and I doubt anyone around me does. As far as setting by ear I’ve never done it so I wouldn’t know what I was doing. Link to comment Share on other sites More sharing options...
Kyblack76 Posted April 11, 2019 Report Share Posted April 11, 2019 Just use your ear. Turn again up, till it sounds like shit, or smells , back it down. Done. Enjoy. At 4 ohm nominal, you will see around 3-500 watts. So, the board makes some sense on that driver,.. to me. you could set the amp with a dd1, scope, and the touch of God, and you'll probably still end up chewing through that driver,. Soooo. Just set the gain where it sounds good, to you, and be smart on the volume knob. Wish ya the best , moving forward. SMD SUPER SELLER The Burban Build Blazer Build sold Acura trunk build sold Link to comment Share on other sites More sharing options...
edgil1985 Posted April 11, 2019 Author Report Share Posted April 11, 2019 I’ve actually got a different path to go. I stopped by a local stereo shop and they have a 5 channel kicker amp that will run my 4 door speakers and the sub. $275 out the door not used just a display piece. I’ll sell the 1200 and put it towards the 5 channel. Use less space. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.