Jump to content
Second Skin Audio

Torres


Recommended Posts

A box with no common port walls would be a box that is using something like an octoport or aero port, even a square port but its in the middle of the panel and not using any exterior box panels as part of the port wall(s).

 

1 common port wall would be a slot port that runs along the bottom of the box such as this *dont mind the 2 center dividers, they are just port braces*.

41.jpg

 

2 common port walls would be a a center slot port that is using 2 exterior sides of the box for the port walls such as this.

20140602_032251.jpg

 

 

3 common port walls would be a slot port on the side that is using 3 exterior walls to make the port such as this.

20150402_204407.jpg

 

Technically 1 and 3 common port walls would be one in the same because both are using 3 sides of the box to make 3 of the port walls. However they are listed differently so that the program can determine the two port orientations out (IE vertically or horizontally) and know which way the port is being used so that it can calculate the port displacement more accurate.

 

 

Link to comment
Share on other sites

On 7/25/2019 at 4:35 AM, audiofanaticz said:

A box with no common port walls would be a box that is using something like an octoport or aero port, even a square port but its in the middle of the panel and not using any exterior box panels as part of the port wall(s).

 

1 common port wall would be a slot port that runs along the bottom of the box such as this *dont mind the 2 center dividers, they are just port braces*.

41.jpg

 

2 common port walls would be a a center slot port that is using 2 exterior sides of the box for the port walls such as this.

20140602_032251.jpg

 

 

3 common port walls would be a slot port on the side that is using 3 exterior walls to make the port such as this.

20150402_204407.jpg

 

Technically 1 and 3 common port walls would be one in the same because both are using 3 sides of the box to make 3 of the port walls. However they are listed differently so that the program can determine the two port orientations out (IE vertically or horizontally) and know which way the port is being used so that it can calculate the port displacement more accurate.

Thank you so much for the help! 

 

Now I know wanna go with 3 common walls :)

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...