Thomas1994 Posted July 25, 2019 Report Share Posted July 25, 2019 The links in Torres no longer work for common port wall...so... Can someone explain common port wall? Trying to put a wall together, and I don't know if I need 1,2, or 3 common walls. Thanks! Link to comment Share on other sites More sharing options...
audiofanaticz Posted July 25, 2019 Report Share Posted July 25, 2019 A box with no common port walls would be a box that is using something like an octoport or aero port, even a square port but its in the middle of the panel and not using any exterior box panels as part of the port wall(s). 1 common port wall would be a slot port that runs along the bottom of the box such as this *dont mind the 2 center dividers, they are just port braces*. 2 common port walls would be a a center slot port that is using 2 exterior sides of the box for the port walls such as this. 3 common port walls would be a slot port on the side that is using 3 exterior walls to make the port such as this. Technically 1 and 3 common port walls would be one in the same because both are using 3 sides of the box to make 3 of the port walls. However they are listed differently so that the program can determine the two port orientations out (IE vertically or horizontally) and know which way the port is being used so that it can calculate the port displacement more accurate. Link to comment Share on other sites More sharing options...
Thomas1994 Posted July 27, 2019 Author Report Share Posted July 27, 2019 On 7/25/2019 at 4:35 AM, audiofanaticz said: A box with no common port walls would be a box that is using something like an octoport or aero port, even a square port but its in the middle of the panel and not using any exterior box panels as part of the port wall(s). 1 common port wall would be a slot port that runs along the bottom of the box such as this *dont mind the 2 center dividers, they are just port braces*. 2 common port walls would be a a center slot port that is using 2 exterior sides of the box for the port walls such as this. 3 common port walls would be a slot port on the side that is using 3 exterior walls to make the port such as this. Technically 1 and 3 common port walls would be one in the same because both are using 3 sides of the box to make 3 of the port walls. However they are listed differently so that the program can determine the two port orientations out (IE vertically or horizontally) and know which way the port is being used so that it can calculate the port displacement more accurate. Thank you so much for the help! Now I know wanna go with 3 common walls Link to comment Share on other sites More sharing options...
DiBo Posted July 29, 2019 Report Share Posted July 29, 2019 Port across the bottom is 3 common walls too if it uses the sides as part of the port... Link to comment Share on other sites More sharing options...
DiBo Posted July 29, 2019 Report Share Posted July 29, 2019 1 common wall up top, 3 common walls on the bottom.  Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.