Jump to content

Recommended Posts

I just received my AMM1 and would like to know how to properly use the true power mode.  I have 2 subs hooked to a monoblock amp...do I need to just run 1 wire from 1 sub through the middle of the AMM1 or 1 wire from both subs?  I tried running 1 wire from 1 sub and got a reading of around 700 watts using a 50HZ test tone, but I'm not sure if that's 700 watts per sub or 700 watts total that the amp is putting out at that frequency.  I also tried that same method with music playing and it peaked out around 850 watts.  The amp is a Rockford T1500 wired to 1 ohm, so I'm assuming that reading is per sub, just wanted to make sure.

Share this post


Link to post
Share on other sites

Yes I read the manual, but it's not very thorough.  It states to only use one wire (as in either the positive or the negative), but it's unclear to me if I should run both positive wires through it or just 1 positive wire through it.

Share this post


Link to post
Share on other sites

just one. 


if nothing changes, nothing changes

You don't know what you don't know, till you don't know

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...