Jump to content

How to get cut sheet in winisd


akuma4u

Recommended Posts

No, it is a simulation and has no concept of the actual enclosure you physically are designing for a cut list.  You need to provide those details as best as possible to the software to test your design and you can figure out the volumes of your enclosure you are thinking of putting together.  I believe Term-Pro and possibly other paid software gives you cut sheets.

 

I'd found this site a few months ago.  I haven't actually used the results from this site but the recommendations match up pretty close to what WinISD recommends and you can easily use the two to get a design going.  These are all simple rectangle shapes, though there are a good variety of type for whatever you are thinking.

 

http://dbdynamixaudio.com/category/calculators/

 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...