Fiesta_glad Posted April 3, 2021 Report Share Posted April 3, 2021 Hello guys ! Well my setup is on Fiesta with stock HU , audiocontrol LC2 , and ampire 2channel with underseat 8" and gladen front speakers RSX 165 ..... so what I did so far ,find with oscilloscope my max HU signal (before distort) I did that with test tone 40hz , 1khz --- 0 db . After that with these thest tones I plug the speaker wires into LC2 and from output with my DMM I measured 6v gain on both main and bass . I did that because amplifier has input sensitivity 0.1 - 6v . After that I set gains in amplifier Full ranger crossover with oscilloscope unit I saw clipping. The test tones that I used is 1khz -5db mid/ highs and 40khz -10db . Have I done something wrong from begging until the end of settings ? Link to comment Share on other sites More sharing options...
Dafaseles Posted April 3, 2021 Report Share Posted April 3, 2021 How bad was the clipping? When you add an overlap, that is you actually introducing an acceptable amount if clipping (nothing more than your speakers can easily overcome within lulls of the song). So if it where a little clipping, that's normal 2011 Chevy Silverado under construction My build log here. Check it out! Link to comment Share on other sites More sharing options...
Fiesta_glad Posted April 4, 2021 Author Report Share Posted April 4, 2021 My clipping was normal not so bad , overlap I dont add only make straight measures ! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.