Dafaseles Posted November 8, 2021 Report Share Posted November 8, 2021 10 minutes ago, Never Enough Bass said: Shitty I get it all in turn it on and now the power light turns on then it switches to the clip light then it switches to the protect light flashes 3 times then does it all over again so idk what happened but I'm gonna have to figure it out later I looked online to see if I could find the owners manual to the SIA-3500D, I couldn't.... But check the troubleshooting part of the manual, or, better yet, it might have a specific section on the lights and what different patterns mean. That's where I would start 2011 Chevy Silverado under construction My build log here. Check it out! Link to comment Share on other sites More sharing options...
Never Enough Bass Posted November 8, 2021 Author Report Share Posted November 8, 2021 1 minute ago, Dafaseles said: I looked online to see if I could find the owners manual to the SIA-3500D, I couldn't.... But check the troubleshooting part of the manual, or, better yet, it might have a specific section on the lights and what different patterns mean. That's where I would start Didn't come with a manual but I'll msg sundown and ask them it was really sad disappointed and I'm grounded to the battery 06 Charger Pioneer double din Pioneer 6.5 and 6×9's Knukoncept Krystal kable rca's 0 ga knukoncept kolossus wire Big 3 same wire ^ 1 run 8g karma ss speaker wire Sundown sia 3500d at 1ohm 2 Sundown U series 12's Duralast platinum agm H7 (Main) Xs power d3400 Trying to find a ho alt Link to comment Share on other sites More sharing options...
Dafaseles Posted November 8, 2021 Report Share Posted November 8, 2021 6 minutes ago, Never Enough Bass said: Didn't come with a manual but I'll msg sundown and ask them it was really sad disappointed and I'm grounded to the battery No manual? 2011 Chevy Silverado under construction My build log here. Check it out! Link to comment Share on other sites More sharing options...
Never Enough Bass Posted November 8, 2021 Author Report Share Posted November 8, 2021 Yea no manual I msgd sundown hopefully the respond back before I have to work tmw 06 Charger Pioneer double din Pioneer 6.5 and 6×9's Knukoncept Krystal kable rca's 0 ga knukoncept kolossus wire Big 3 same wire ^ 1 run 8g karma ss speaker wire Sundown sia 3500d at 1ohm 2 Sundown U series 12's Duralast platinum agm H7 (Main) Xs power d3400 Trying to find a ho alt Link to comment Share on other sites More sharing options...
killerc998 Posted November 9, 2021 Report Share Posted November 9, 2021 You can download the manual off sundown. Amplifier Goes Into Protection Check shorts on speaker wires or open coil. Check input voltage from RCA, if DC signal is over 4 volts, the amplifier will go into protect. Remove and reset the power to the unit to check if it will turn on. Check impedance to make sure it’s over the minimum load, see the specification charts in this manual for the minimums of your specific amp. Check input voltage. The amplifiers covered in this manual have a working range of 10.5 to 15.5 volts. Check chassis ground and remote using same ground. This is also from the manual Note- The PWR, CLIP, and PRT leds will flash as a test when the amp is first powered on. Link to comment Share on other sites More sharing options...
Dafaseles Posted November 9, 2021 Report Share Posted November 9, 2021 1 hour ago, killerc998 said: You can download the manual off sundown. Amplifier Goes Into Protection Check shorts on speaker wires or open coil. Check input voltage from RCA, if DC signal is over 4 volts, the amplifier will go into protect. Remove and reset the power to the unit to check if it will turn on. Check impedance to make sure it’s over the minimum load, see the specification charts in this manual for the minimums of your specific amp. Check input voltage. The amplifiers covered in this manual have a working range of 10.5 to 15.5 volts. Check chassis ground and remote using same ground. This is also from the manual Note- The PWR, CLIP, and PRT leds will flash as a test when the amp is first powered on. I looked, I couldn't find the damn manual lol. But that was exactly what I was looking for. Thank you! And I'm sure @Never Enough Bassthanks you too! 2011 Chevy Silverado under construction My build log here. Check it out! Link to comment Share on other sites More sharing options...
killerc998 Posted November 9, 2021 Report Share Posted November 9, 2021 You go to amplifiers click on the sia-3500. Scroll down to product manual. When you download it, it will say sbf, but the sia-3500 is in the same manual. Link to comment Share on other sites More sharing options...
Never Enough Bass Posted November 9, 2021 Author Report Share Posted November 9, 2021 10 hours ago, killerc998 said: You can download the manual off sundown. Amplifier Goes Into Protection Check shorts on speaker wires or open coil. Check input voltage from RCA, if DC signal is over 4 volts, the amplifier will go into protect. Remove and reset the power to the unit to check if it will turn on. Check impedance to make sure it’s over the minimum load, see the specification charts in this manual for the minimums of your specific amp. Check input voltage. The amplifiers covered in this manual have a working range of 10.5 to 15.5 volts. Check chassis ground and remote using same ground. This is also from the manual Note- The PWR, CLIP, and PRT leds will flash as a test when the amp is first powered on. Yea thanks I'm gonna check it out today I know it test like that but this just repeats over and over 06 Charger Pioneer double din Pioneer 6.5 and 6×9's Knukoncept Krystal kable rca's 0 ga knukoncept kolossus wire Big 3 same wire ^ 1 run 8g karma ss speaker wire Sundown sia 3500d at 1ohm 2 Sundown U series 12's Duralast platinum agm H7 (Main) Xs power d3400 Trying to find a ho alt Link to comment Share on other sites More sharing options...
Never Enough Bass Posted November 9, 2021 Author Report Share Posted November 9, 2021 My volt meter is hooked up straight to the amp I'm seeing 14.4v and .y ground is hooked straight to the battery 06 Charger Pioneer double din Pioneer 6.5 and 6×9's Knukoncept Krystal kable rca's 0 ga knukoncept kolossus wire Big 3 same wire ^ 1 run 8g karma ss speaker wire Sundown sia 3500d at 1ohm 2 Sundown U series 12's Duralast platinum agm H7 (Main) Xs power d3400 Trying to find a ho alt Link to comment Share on other sites More sharing options...
Never Enough Bass Posted November 9, 2021 Author Report Share Posted November 9, 2021 So my sfb 1500 works but my 3500 is still doing the same thing 06 Charger Pioneer double din Pioneer 6.5 and 6×9's Knukoncept Krystal kable rca's 0 ga knukoncept kolossus wire Big 3 same wire ^ 1 run 8g karma ss speaker wire Sundown sia 3500d at 1ohm 2 Sundown U series 12's Duralast platinum agm H7 (Main) Xs power d3400 Trying to find a ho alt Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.