Joshk Posted September 17, 2021 Report Share Posted September 17, 2021 Hi, every time i try to use subbox pro or winisd it goes crazy . im trying to get blprints/ measurements for and enclosure .plz any help is welcome. If possible center port 2 skar vxf 12s d4 tuned at 32. Id like 2cbft^3 per sub after displacement. My max dimensions in trunk are 13h,36w,24d. That would fit in nicely. Im running 3k smart taramp. Im going to wire final 1ohm to amp. The displacement for one VXF-12 is 0.233. Recommended Ported Volume: 1.80 ~ 2.00 ft³ Recommended Port Area: 29.75 in² Recommended Tuning Frequency: 32 Hz Enclosure recommendations above do not include subwoofer, bracing, and port displacement SUBWOOFER MEASUREMENTS Cut-out Diameter 11.13" Mounting Depth 8.50" Total Height 9.33" Outside Diameter 12.49" Magnet Diameter 8.63" 12-inch Dual 4 Ohm Voice Coil Configuration Peak Power: 3,000 Watts RMS Power: 1,500 Watts Competition Grade Pressed Paper Cone Stitched High Roll Foam Surround Advanced Air Flow Cooling System 3" High Temperature Copper Voice Coil Motor Weight: 300 oz Frequency Response: 22 - 250 Hz Sensitivity: 83.6 dB Fs: 34.4 Hz Re: Dual 4 Ω Qms: 4.46 Qes: 0.47 Qts: 0.43 Mms: 319.9 gr Nref: 0.19% Cms: 0.07 mm/N Bl: 33.8 n/a Vas: 22.7 L Sd: 471.4 cm² Xmax: 25 mm If you need to go wider you can go up to 40 and deep you can go 28 if needed. Thank you Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.