Jump to content
XS Power

Recommended Posts

Hey nathan its Anthony from New orleans. I installed everything in yesterday and it works amazing!!! Only problem is im worried about my voltage being so high, this morning i started my truck it was reading almost 16- 15.9 with the blower for the heater on. when i turn the blower off it drops to around 15.3.

LAst night i set it to 14.6 and when i ut on the heater/blower it jumped up to around 15.1.....WTF IS GOING ON!!!!!!! and the lowest i can set it to this morning was 14.5 except it still runs around 15.1

TermLab 148.9 @ 39hz BURP

148.8 on music

Link to comment
Share on other sites

That is probably the variance in your alternator output. When it cold it will charge at higher voltages, and then after 30mins to an hour of drive time it drops back down. You could set the VCM to 13.6 or so tonight and then check it again in the morning at start up and see if it does the same thing. This is pretty normal with the alternators we tested.

RealPower800x135_zps58408f90.jpg

Link to comment
Share on other sites

That is probably the variance in your alternator output. When it cold it will charge at higher voltages, and then after 30mins to an hour of drive time it drops back down. You could set the VCM to 13.6 or so tonight and then check it again in the morning at start up and see if it does the same thing. This is pretty normal with the alternators we tested.

will it mess up my battaries at such a high chargevoltage rate?? oh and by the way did you catch the pictures in my build log of the VCM coments are greatly appreciated :rolleyes:

TermLab 148.9 @ 39hz BURP

148.8 on music

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   1 Member, 0 Anonymous, 1141 Guests (See full list)

×
×
  • Create New...