[What's Wrong?]

he has d2's so ied wire each sub pos to pos n neg to neg n then run a wire off the left subs neg to the right subs pos coil, n then run a wire off the left subs pos coil to the amps left pos, n run a wire off the right subs neg to the right neg on the amp n u should be good wit ur 2ohm load

my buddy had 2 or 3 subs runnin off his nitro 1200 n it worked ok, pushed 2 rf punch he2's pritty good, n i got em off him n my mtx 500d did better but ya

ied wire it like that, or heres a pic of how to do it too, i just wire it like that cause it leaves less wires at the amp to work wit

haha rf does it too =)

heres the pic

if u wired ur subs together n then the same at the amp and u did this

u down to .5 ohm n fixin to blow shit up in that amp n need to rewire asap lo

hope this helps

i get what your sayin but how am i gonna run wires from sub to sub when my box is chambered?

[30 or 31hz Songs]

could anybody give me some songs around 30 or 31 or even 29 hz?

[What's Wrong?]

how are they wired series then parallell correct? if so you may have low voltage

on the dash its readin about 15 volts so i wouldnt think thats the problem....i only have 1 on there right now wired to 2 ohms bridged and it does just fine

[What's Wrong?]

maybe bc ur amp cant take a 2 ohm load

but on the amp it says minimum impedance is a 2 ohm load

[What's Wrong?]

i have 2 Cerwin Vega HED 12.2's and when i wire them to 2 ohms and bridge them to my amp it always goes into protection mode when it really hits...could anybody give me some advice on what to do?

[What's Wrong?]

why is this in tunez?

didnt mean to put it in here my bad

[What's Wrong?]

I have 2 Cerwin Vega HED 12.2's and when i wire them at 2 ohms and bridge them to my amp, my amp always goes into protection mode when it really hits...could anybody give me some advice on what to do?