-
Posts
298 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Media Demo
Store
Collections
Videos
Posts posted by HaMSaMMiCH
-
-
mwhahaha my ninja skillz are moar far superior to your interwebz skills meade
:o
ninja some pics with speaker wire next!
-
some decks require you set/unset the parking brake to get the video on. those are the ones that need a switch. a few pioneers i have seen the pb wire needs to be grounded when the unit is hooked up to power. just ground the light green wire and if it doesn't work, unhook the wire turn the radio on then ground it.
also, i didn't tell you that.
-
i counted 3 L5s, 2 W1s and a W7. Smoke crack much?
-
Good shit sir, can't wait to see where you shoehorn in all those amps!
-
I've been wondering, sense you run umpteen amps and processors, what do you do for remote? Remote from HU to relay hooked to constant? Or does the 360 have a remote output?
-
I guess what I was trying to say there is that it doesn't really matter as long as the ground potential isn't radically different. I wasn't trying to say that you are an idiot, I didn't know your battery placement and tried to provide as much information as possible so you could apply it to your install. Every install is different. If you can put the batteries right near each other, by all means ground to the same point. If they are on opposite sides of the vehicle find a good ground near the batt. Whatever works for your particular situation.
-
HEY! THAT IS SUPPOSED TO BE A B WITH A ) NEXT TO IT NOT A !!!!!!
-
i'm going to be starting the wiring up here shortly for my new setup, and was wondering about this ground question: I have 2 rear batt grounds from my 2 rear batts, but should both ground to the frame at 1 spot, or should they both be grounds at their own spot?
It depends where the batts are in relation to each other. Grounds should be kept as short as possible. You can ground them together or separately, what you need to consider is A) wire length, clean ground connections, C) ground potential.
The wire length is pretty self explanatory. When you do connect the ground to metal, make sure it is bare metal and use some sort of protection over the connection to prevent rust/corrosion. As for ground potential just make sure you are using a piece of sheet metal or frame that is of low resistance; I.E. not a body panel that is welded to the unibody like fender wells. If you have a DMM, hook a lead to the negative terminal of the main battery and use the other to check where you want to ground. Just look for the lowest resistance and try to have the same ground potential for both batteries.
If the batts are close, ground them together, just use appropriate gauge wire.
-
lol.
\there are only 6-7 cameras in that store..lol
I got more than that at Steve's house.
Anyone wanna guess what song MR.MEADE was signing in the shower this morning? lol
Good Vibrations?
-
Hi,
My name is Gomez
I'm from NY
I live in FLA
I'm 22
MECP Basic(going for advanced when my basic expires)
I've been installing for 5 years
Installed my first system parked on Starr Ave. Toledo, OH(I will forever remember running that shitty 8ga to that shitty MTX amp while dodging traffic)
Currently my system is sitting in a neat pile in the corner of my room while I get my Silverado back on the road.
Early 2010 upgrading to Alpine CDA-9887,(2) t1500bd,t600-4,(4) undetermined 12's,(4)pair Infinity Kappa 6 1/2
Tahoe System Rebuild 2009 is ALL BUT FINISHED and PLAYING!!!! UPGRADE to RF P2 8's 12/08/2009!
in Just Meade....my projects - Tons of SMD Builds here!
Posted