bigjay
-
Posts
26 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Media Demo
Store
Collections
Videos
Posts posted by bigjay
-
-
i know right thank god for dip shit protectionwhat happens when you strap is each amp sees half the load it normally would. .8 would be fine on a single amp but that drops you to .4 strapped. thats why you're amps shut off. Say thanks that the protection kicked in and they didnt smoke
-
hey thanks guys for all the help no matter how funny or stupid my questions may have been
-
well im glad u got a kick out of itso the resistance of the probes is .4ohm and you see .8 at the terminals. so your wired to .5ohm. each amp sees .25ohm. thats the answer. you wired all the + terminals together and all the - terminals together. wire them to 2ohm and you will be good.
noob help is funny
-
thanks i will wire them up 2ohmsproblem solved. I was off by .1 can we chalk that up to the meter
-
im using 8 gauge wireIt could be that ur wire gauge is too small, this happened to me. like it would go to protection when the vol. got too high so i got bigger speaker wire and it never happened again.
-
thats what the meter says? what does it say if you just touch the 2 probes together? .3?
i went from poistive from master to poistive to slave .4 if i touch probes
-
then what is your final ohm load to your amps? do you have them wired series parallel?
.8 ohms
-
or strapping i bet he's got them strapped at one ohm. each amp seeing .5
im at .8 ohms
-
are both amps going into protect, or just the slave?
the master amp only
-
If you dont know what "impedance" is, i dont think you should be playing with 4000+ watts.
i know what ohms are
-
Do they are 1 ohm stable when strapped ? They may accept only 2 ohms. So, what kind of subs do you have ?
hdc3 15s 2ohm
-
impedence,,,,and do you have enuff juice to supply those amps,,is your voltage dropping to low
i have 3 kinetic 912 its round 14.2 13.8
-
Yep, it could be a ground. Did you sand off any paint or rust?
Also, is the impedence too low?
i just hooked it on the set mount and sanded the paint how u know if the impedence is to low
-
i did what the manaul said to do would a bad ground make this happen because i did relocate the ground
-
hey guys i just linked a pair of 2200d audioque and they keep going in protection mode when i trun it up whats up with that
-
my audioque keeps shutting off
in General Audio - Can't find a category for your question? Ask here.
Posted