Jump to content

Dj_Scarface

Members
 View Profile  See their activity

  • Posts

    1140

  • Joined

  • Last visited

 Content Type 

Posts posted by Dj_Scarface

  4. XS Power IntelliCharger advise/support TIA

    in XS Power Batteries / Chargers! (and other stuff too)

    Posted

    Not really a trade in program put in place.

    They are set amperage units, so there are 15amp, 30amp, and 60amp units.

    If you are only going to use it as a power supply, then you would look at the amperage draw your electrical system would be pulling with the car off at a car/trade show. If you are going to use it as a charger, then go as big as you can afford if you have a bank of more than 3 batteries. If you have a bank of batteries then you can basically take the amperage output available and divide it by the number of batteries. That will give you the basic amperage each battery is going to see during charging, so if you have 6 batteries and the 60amp IntelliSupply then each battery would see around 10amps each. If you had the 1005 charger and a bank of 6 batteries then each battery would only see around 4amps. Optimal charge rate is around 15amps per battery.

    ""If you are going to use it as a charger, then go as big as you can afford if you have a bank of more than 3 batteries."" <~ quoted from above

    So if I go IntelliSupply instead of IntelliCharger would the math not matter?

    Because forum read & forum searching (5-6) xp3000 would be fine on just the (1) HF1215 IntelliCharger but if I use just the (1) IntelliSupply I should be saving for psc60 & not the psc15...

    Using for both shows & charging it I can every keep the ball rolling on this project

  12. M2 inside a M1

    in DC Sound Lab - Big Bass on ANOTHER LEVEL!

    Posted

    I wOuld definitely recommend gettin the new level 4 recone. The new 4 coil is a flat wound coil. The old level 4 coil is now used in the level 3.

    KOOL!!

    Will two m1 lvl 4 with m2 soft parts cause any problems or noticeable audio difference if I put them in a box with two all stock dc lvl 4 m2???

    No DO NOT do that. They will act differently.

    Well there goes that plan

  14. M2 inside a M1

    in DC Sound Lab - Big Bass on ANOTHER LEVEL!

    Posted

    i have 2 m1 lvl 4 motor/ baskets with m2 recones. they run great. its the same just upgraded to the flat wound coil. rms is around 1000 to 1100 i think... but dont quote me on that.

    Good to know... Not I can get the blown m1 lvl 4 motor/ baskets for the extra low.

    Still need to see if putting them both in the same box will cause problems...

×
×
  • Create New...