Brags
-
Posts
32 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Media Demo
Store
Collections
Videos
Posts posted by Brags
-
-
or you could just have bad 4ga wire.
i think that might be it oh well idk ill keep messing with it and see if i can do anything about it but if not i will just buy a new kit
-
Check ground. Make sure you sand paint off etc etc. And the gain knob isn't a volume knob. Don't fry your woofers.
ok i will re-clean the ground are and my amp is under powering then i doubt they will fry im scared for the amp
-
ok so i just upgraded from 8 gauge wires to 4 gauge wires on my 2 db drive platinum series dvc 4ohm they are wired to a kicker zx750.1 and when i had the 8 gauge wires it would hit harder and now with the 4gauge it hits hard but i have to turn up the gain and everything to get close to what i had with the 8 gauge and my voltage goes down alot more any idead on what i should do ?
This wire upgrade from 8 ga to 4 ga was this power to the amp or the speaker wires from Amp to Sub ?
this was a upgrade for the battery to amp wires
-
ok so i just upgraded from 8 gauge wires to 4 gauge wires on my 2 db drive platinum series dvc 4ohm they are wired to a kicker zx750.1 and when i had the 8 gauge wires it would hit harder and now with the 4gauge it hits hard but i have to turn up the gain and everything to get close to what i had with the 8 gauge and my voltage goes down alot more any idead on what i should do ?
Did you make the area for your ground a little bigger and cleaner since the terminal for a 4 gauge would be a little bigger?.. check ground.
the terminal is actually almost the same size and i cleaned off the area of the ground and everything im just trying to figure out why it hits harder with the 8 gauge rather than the 4 :/
-
ok so i just upgraded from 8 gauge wires to 4 gauge wires on my 2 db drive platinum series dvc 4ohm they are wired to a kicker zx750.1 and when i had the 8 gauge wires it would hit harder and now with the 4gauge it hits hard but i have to turn up the gain and everything to get close to what i had with the 8 gauge and my voltage goes down alot more any idead on what i should do ?
-
-
i like the aq1200 a lot but would it be stable at 1ohm ? ohh and the DB's are dual voice coil 4ohms
-
-
-
yeah i know what you mean i have been looking for one in about the 150-200 range but i want a MTX or Alpine but just not sure which one would be good ?? i need at least 1000 watts
-
kam yeah i have been looking for a better amp because i understand that mine is under powering the subs but i need a decent priced one and Bryce i checked that to i tried it all but no luck it has to be the amp
-
Thanks i went out to try it but unfortunately it didn't work im guessing its just the amp :/
-
I have no idea what is going on with my 2 db drive 12s they are moving with no music playing they where working fine a few days ago till now. As soon as i turn on my truck they start moving. Please help
The subwoofers are 750rms 1500max each
The amp is a Boss 600x2
I am using 8 gauge power and ground wiring
i have checked everything thing the remote wire, Ground, power,and the fuses
click on the link below to see what im talking about
Help with wiring
in Off Topic - Random, Misc posts - the forum "Junk Drawer"
Posted
yea guess your right well im gonna just do what these guys said and just clean up the ground area