Are these measurements correct?

[yUmadBro]

bump

[Saltine]

youll have to play with the port numbers a bit, see where it says "port area range 30-40 and your "port area" is 23, you have to be between 30-40, i know a wider port willget you closer, you may have to extend the depth of the port also

[yUmadBro]

youll have to play with the port numbers a bit, see where it says "port area range 30-40 and your "port area" is 23, you have to be between 30-40, i know a wider port willget you closer, you may have to extend the depth of the port also

thanks

[yUmadBro]

Hope this is a little better

[Saltine]

if you want to be tuned to 35hz and 2.33cubic foot is in the specs of after displacement airspace, yep looks good to me

[yUmadBro]

I was shooting between 2.25-2.50 cu. feet. But why isn't there any port dimensions on the cut sheet? That's mainly what's confusing me now