[Hifonics Olympus Olm2415]

It's a 06 I was hoping some guys with more experience with trailblazers could give me a hand designing and draw up a box for my truck .

Thanks, Dan

[What Should I Do?]

cool guys I will be checking it out today.

[What Should I Do?]

Stick with the 1/0awg. Once you pull the door sills off you should easily be able to stuff 1 run of 1/0awg wire into there.

Thanks guys I wanted to use the 1/0 anyway I have not popped up the door sills yet to see how much room I have there as far a running it under the truck where would I get through in the back?

[What Should I Do?]

I want to take my system out of my mazda and put it in my trailblazer with the 0 gauge in my car I have a big hump from the wire under thr carpet I dont want my TB to have that so I was thinking of doing 2 runs of 4 gauge would that work just as good?

[4.3l Running Issues]

How long will it run? If its like 2 seconds its timing. Also the starter may need a shim. 4.3's are quality motors. just my .02 cents. I seen them get 250,000 without a sweat when maintained right.

+1 I had a 95 s10 with that motor and I sold it with over 230,000 on it and it's still going with 300.000+ on it

[Rap Video Dvd's]

Thanks guys they are for my ride to watch on long trips.

[4.3l Running Issues]

I have no idea maybe check the camshaft and crankshaft sensors and map sensors. Good luck hope you figure it out those are good motors.

[Rap Video Dvd's]

I have purchased a few off ebay from a guy in canada and the quality sucks I was hoping some of you guys could tell me where to buy good quality stuff.

Thanks, Dan

[Hifonics Olympus Olm2415]

If my shit is clipping is from over or under powering my sub? Sorry if thats a dumb? I just dont want mess my shit up if there is something wrong.

[Hifonics Olympus Olm2415]

my dmm leads must be bad it reads all over the sub sounds fine and plays loud and I double checked the wiring and it's wired for 1 ohm. the amp and sub are brand new so maybe it's clipping because I dont have enough voltage.

[Hifonics Olympus Olm2415]

idk you may be clipping the sub even with the electrical upgrades you have.

Yeah I was thinking that too. My voltage is between 12v-13.8v, I need to get my kinetik in.

[Hifonics Olympus Olm2415]

Gains set correctly with a multimeter?

Have you checked your sub resistance at the amp (speaker wires disconnected of course)?

No I did not check the resistance bit will.

wired in parallel hopefully?

dmm... did you set the ac voltage to 49v w/50hz test tone @ 3/4 volume?

the brutus amps do get warm... especially at 1 ohm

I set it too 48v but it's too much for the sub in this box I think I had to back the gain off.

[Hifonics Olympus Olm2415]

anyone?

[Hifonics Olympus Olm2415]

IMO there is no way of helping you without more info.

Woofer specs.

Box specs.

Electrical Upgrades if any?

need more info

Here are the specs of the sub http://www.maxxsonics.net/manuals/hifonics...er%20Manual.pdf

Box is 3.49 cu. tuned to 36 hz

optima yellow top d35 under hood, big 3 done, 0/1 wiring single run, 8 gauge wire for the sub. And 180 amp alt.

[Hifonics Olympus Olm2415]

I noticed that the cone was getting a little warm after playing for a few minutes. I did not smell anything burning. I use a Hifonics BXi2608D, the amp gets a little warm too but not now where hot so I think that is normal. But is this normal for high power subs? Any help would be great.

[My Shit Is Bangin]

Huh?

You can burn a song on a disc and if someone decides to jack your shit they would need that disc to use the deck.

coo coo..

Igot a buddy in wausau that is a competiter that hasnt herad me since i got my amps, ill be heading up there in a couple weeks when I get my other sub back.. if its on the way we can meet up!

Team WallSconsin :hairtrick:

That would be cool. I'm about 40 mins. south of wausau.

[My Shit Is Bangin]

Thanks for showing love guys. More vid will be up tomorrow.

[My Shit Is Bangin]

I always liked Eclipse idea of using a cd to recognize for security, better than a damn pass codes

good system man, lookin good

Yeah the eclipse is great puts out some quality sound. And the security disc is a plus.

[My Shit Is Bangin]

Looks like its slappin! Glad you like it. Good job man!

Yeah man it's alright I will get another vid tomorrow after work. I'll show the sub moving too.

[Wont Start]

Maybe bad gas or something. good luck

[My Shit Is Bangin]

stevens point

get me a damn beer homie

nice flexin

Thanks, My cuz lives in cary, IL. Maybe I'll be at a show there someday.

[My Shit Is Bangin]

looks good!! it bout time we find another wisconsinite:) i live in the lacrosse area...hope to see ya at some of the comps nxt year....

For sure man, I want to take it down to the local stereo shop and see if he will put it on his TL. But he will be hatin because I didn't this stuff from him but who knows.

[My Shit Is Bangin]

Yeah, your shit is banging, look what it did to your Rear Drivers door!

LOL. Maybe if I build a wall with 4 of them and face them at the door it would look normal.

My car is a hoopty. system is worth more than the car. LOL

[My Shit Is Bangin]

I'm in stevens point central wi, I have never been in a comp but I might try now that I have something that is kinda loud.

[My Shit Is Bangin]

Well I did not get my kinetic 600 in because I have to build a rack for the amps so there is room. But I'm very happy with this enclosure and sub/amp combo. It's the loudest shit I've had. I will adjust the amp a little more after the sub plays for a week see if it gets any louder. I wonder what kind of db's I'm getting?