Jump to content

ROLEXrifleman

Members
  • Posts

    3140
  • Joined

  • Last visited

  • Days Won

    19

Posts posted by ROLEXrifleman

  1. 1) Figure out what level you going to use. 0, -5, -10

    2) DD-1 your deck

    350f29d2.jpg

    3) connect the deck to the 3sixty. Leave deck at highest uncliped level. Connect DD-1 to output of 3sixty and adjust the 3sixty gain till there is no clipping.

    f4783f41.jpg

    4) leave your deck at it's highest unclipped level. Leave the deck connected to the 3sixty, connect 3sixty to amplifiers(s). DD-1 output of amps

    7116706f.jpg

    5) your done

    • Like (+1 Rep) 1
  2. DD-1 your radio output

    Connect to your 3sixty

    Leave your radio at it's highest unclipped level

    DD-1 output of 3sixty

    Connect to your amps

    DD-1 your amp output

    It's how I did the EPX2, time consuming but worth it.

    7a8893a2.jpg

    This thing has level LED's as well. With the tune everything was as it needed. The red clip light on the EPX2 does not come on. Not sure what your running but i was able to take a 4 volt out alpine and run it into my EPX2 and bring the voltage down to feed older Fosgate amps that only allowed for 3V in. Just sayin in case thats something your facing too.

    • Like (+1 Rep) 1
  3. I find it funny that probably 99% of members don't see the connection between Zetar and planet audio.

    Anyway, zed rated this amp at 1000x1 @ 4 ohms no question it does every bit of that, and a LITTLE more. But um sorry to say this thing will not come close to 2k let alone 5k.

    It's an old school 2 channel so no lower than 2ohms stereo or 4 ohms bridged

  4. It's all about kinetic energy on soft tissue

    At 100 yards a .50bmg has 12,000 foot lbs of energy as opposed to the s&w's 1900 foot pounds at the same distance.

    Next time your the lake pick up two rocks close in size. The 1st one just let fall out of your hand into the water, the 2 nd one wind up and throw full throttle into the water. That's the difference.

×
×
  • Create New...