HondaMan450R

BTL's!

Quit smoking....

I don't know the answer to your question....... but I damn well know she it HOT.

I have a t2000.1 thats only got 1 hour of use on it, if your still looking.... Birthsheet said 3158 watts rms@1ohm, and still under warranty.

The BIG 3 is upgraded (bigger size) ground wires. 1 from battery neg. to frame of car 1 from frame of car to engine and 1 from alternator to positive battery post

I know. It's for matching to amp to the source units preout voltage. I just stated that for no reason I guess. Either way the amp is no where near clipping.

I have a Rockford T2000.1bd in my car with stock electrical, except for the big 3. I have the amp hooked up to two 12 inch Alpine Typr R's @ 1ohm at the moment. The amp is not turned up much at all, maybe 15% gain with 2volt preouts on HU, with no bass boost. With deeper bass, sometimes the volts will drop to 11. I was just wondering if this is low enough to damage the amp? If not, what is the ''danger point?''

Do you know which version I would need? I see there is a version 6, 7, and 8. Or do they all do it?

just make test tones with audacity. you can make them from 1hz and up....

Hey guys. I was just wondering if you can use Audacity or a similar program to change bass frequencies in songs? Take 'Hood Nigga' by Gorilla Zoe for example. The steady note peaks at 31hz. Can you raise that frequency from 31hz to, say, 45hz while keeping the same beat? Hope this makes sense. Thanks. Nathan

lol

And at the moment it is powering two 12'' Alpine type R's.....haha they haven't blown yet after about 5 hours use. But the gain is at the most 10% up and no bass boost....and the t2000 is raping them!

Haven't decided yet....but it will be either two 15'' Fi BL's or one 15'' Fi BTL. I want the louder on of the two. Any suggestions?

Just got a new Rockford Fosgate T2000.1BD a few days ago and wanted to see what you guys thought about my birthsheet.... Please comment....