yes the are of the port has to be the same through the whole port. to get the correct length on an L shaped port you would measure how deep you can go with it and then subtract half of the width of the port and then turn and do the rest of the port to the side but again you half to subtract half of the width. so if you had a port that was 4" by 12" by 20" and your box was only 12" deep you would measure back 10" and then make your turn and measure from the center of the port over for the remaining 10". you basically just need to measure down the center of the port to get an accurate length. hopefully that makes sense to you and if not i think kicker has a section on there web site that explains it a little better with a picture