Wish I had heard of it before I ran over to Walmart and picked up a bottle of Gorilla Glue and some Loctite.
Next time I would use more clamps but I have a general rule of 1 screw per 5 inches because last time I built a box, I had screws every 2 inches and I was told it wasn't necessary.
Anyways, I finally finished up the install. Got all of the box carpeting and gluing completed. I took out the cargo area carpet and redid all grounds in the vehicle. I rearranged the wiring in the front of the cargo area, where the sub box lies before the amp. I took out the cargo latches so that the sub box would lie flatter and then I got the great idea of bolting the box to the cargo floor. There was a rubber plug that led straight to above the spare tire, so I took measurements and then drilled a hole into the box. I gathered a bolt, some lock nuts, a few washers, a rubber gasket, and my Loctite. I assembled the pieces and put the sub box in the cargo and put Loctite in between the rubber gasket and the wood to form a tight seal. After I finished installing the box, I wanted to make sure that my amp gains were tuned correctly. I set my head unit to flat, MX off, unhooked my sub and inserted the leads into their determined terminals. I set the LPF to 70Hz and the bass boost to off. After some adjusting, I got the gain to hit right on spot of my destined voltage, 48.9V. All went well, and the bass seems more controlled and not getting sloppy as I had noticed before, so early on. I am now well aware of what a leaky box sounds like, and a sealed ported box sounds like. One thing I was unsure of was, what exactly is the MX on/off function? To me, it just seemed like it caused the overall volume to increase faster as I turned the knob, like what I would play at 26/35 with the MX off, would sound like 15/35 with the MX on.
Before the sub box was put in it's proper location
After I pulled the plug out, I cut a small hole in the carpet so that I could insert the bolt through here and tighten it from underneath the truck, providing a sub box that does not slide around and somewhat of a theft deterrent, but of course they could just undo the 6 wood screws... T-nuts next, maybe?
Overall, I'm pretty pleased with the results.