RXdriver11

That tell me what I need to know. Thanks a bunch guys. Would you recommend setting it to the exact voltage it says, or a little lower just to be safe? Regardless of what voltage you set it to you might still be clipping and the only way to find that out is to scope that bad boy.. I had my voltage set correct on my last setup but when I got my O-scope I found out I was clipping hard..

Some people are haters plain and simple. Speaking as a young black male who has experienced his share of racist run in's, this is the society that we live in. Steve thanks for bringing attention to this issue and getting that youtube page shut down. But lets just be real there will be another one just like it back up before you know it. I figure the narrow minded idiot who runs the site has nothing better to do with his life than hate on people of a different race. While I have a life, a career, a girlfriend, a bitchin car audio system, and other hobbies that dont allow me time to hate on those who have what I want. If someone is gonna hate on you that hard it lets you know that you are doing something right, and usually when they start talking that hate shit I just turn up the volume knob and drown them out with the bass. On another note Steve Mead if you read this I want to know if you still have your crossovers from your T1652-s.. I'd like to buy em from you. (or accept them as a free gift )

Oh yeah Steve if you still have those crossovers from your T1652-s are you interested in getting rid of em? Sell, give away, or trade??

First off you need to go to your friend.. look him dead in the face.. proceed to raise your right hand at a 45 degree angle.. and backhand him.. then go find a badass 18" sub throw some watts at it, with a 15.1v system and 4 batteries and hair trick that fucker..

Well for me when I was looking I would go to Frys Electronics and drop a few hundred on one, use it and return it after I was done (yeah yeah i know). But I found out that I needed it more than I thought so I shopped ebay till I found a good deal on a used one. Most of the places I found that would rent them were electrical test equipment shops and they rented for just as much as some cost. Just save your $$$ and look for a good used one or new if thats your thing. If cost is the issue it will be far cheaper than killing and replacing your equipment from clipping..

Steve.. do you still have the crossovers from your t1652-s in the tahoe? If so you wanna get rid of em??

Looking to buy some RF crossovers for T1652-s components..

Dont forget under the seat. I just put mine under the front seats. there is plenty of room for me and they are out of the way but still easy to get to if I need to make adjustments..

i thought about that but for the price with the sale they have i might just spend a few bucks and see how they do.. thanks. im not new but not old here either. I spend a lot of time on here but mostly reading and learning.. dont worry bout that. no need to install something you werent going to do anyway lol.. I just wanted to know if anyone has used them and what results they got. my doors arent deadened yet either..

Has anyone here had any experience with the speaker tweaker pads?? Good.. bad.. anything?