Ds5381

I used to do all this myself I want to get back into doin my own installs. I should post pics of some of my old installs. I'm not a noob just been out of the game for a while lol

I believe it's off the factory sub.

I didn't do the install. I kinda wish I did now. I had a local shop do it. They are very reputable so I hope it was set rite.

Haha everything I sealed. I'll have to take half my car apart to get to it.

Yeah it's not powered. I'll try a new ground first then if that doesn't work I guess I'll go that route. Thanks

Will do thanks. I'll update if its a success

Also everything is in the trunk so it's only 3ft of cable from the amp to the battery. I am using the factory radio with a hi/lo filter. Could that be the problem?

The amp doesn't get hot at all. The wiring is 4g and the amp is on a 2ohm load. Previously I had a DA 600 mono and didn't have any problems. I know the kappa one is 800w RMS and 1600w max and the amp will go into protect mode when the gain is set rite even at 3/4 volume and the bass boost down? The ground is installed to a factory ground in the trunk.

The gain is set way too low. If I set it rite then the draw is too much and the amp goes into protect mode. Is this common to have this much draw with an 800w amp? I'm kinda hesitant to do the big 3 cause the car is a lease but will upgrading my original battery have any effect?

*09 genesis

Hey everyone, I'm runnin 2 infinty 1209's in a vented enclosure pushed by a kappa one amp. The power drain is too much and the gains not even high? The vehicle is a 09 genesis 4dr and I don't want to start doing to much to it cause it's a lease. Any suggestions would be greatly appreciated. Thanks