lucky623

i got it today my subs are loud as fuck you sir were wrong and must of had a bad experience with power accoustik

thank you very much for the info thread and your detailed answer.

okay now that im a little more educated, it will power them just not to their full potential? for their full potential i would need an amp with 1000 rms rating correct?

But will it power those subs? Sorry but i dont know what rms or anything like that is.

Ok so i dont know shit about ohms and all that stuff, I do however know i like loud music. Any help would be greatly appreciated and i thank you in advance. So here goes i just got a pair of rockford fosgate p3d412's and i was looking at getting this amp The subs are wired to 1ohm i think because when i looked in the box it was all looped and what not and theres only one spot on the box to plug the speakers to the amp. POWER ACOUSTIK OVN1-2000D Gothic Series Class D Mono Amplifier (2,000W) * 2,000W max * 1Ω mono stable * Gunmetal gray anodized finish with chrome accents * MOSFET power supply transistors * Pulse width modulation circuitry * 3-way protection circuitry * Bridged synchronization * Low pass & subsonic filters * 200mV–8V low level inputs * Preamp outputs * Dash-mount remote gain control * Freq resp: 10 Hz–30 kHz * Signal-to-noise ratio: 98 dB * Total harmonic distortion: .02% * 4-gauge power & 8-gauge speaker terminals * Dim: 3"H x 10.63"W x 10.88"D * 600W x 1 @ 4Ω * 900W x 1 @ 2Ω * 1,200W x 1 @ 1Ω , I would go with a fosgate amp but its just way out of my price range So basically will this amp power my subs or will it be too much or too little?? thanks alot