triplec19

wanted to know if I could check it out before i bought one for myself n see it work on your system.

So would running the wires like this also be the same as lagexe has posted?

Bump, tryn to install today, thankss

Is this correct with the front wired normally? Also is this safe for the speakers, i know to be careful with the power delivered

You can run different ohm speakers on the same amp? Is this because it is an AB amplifier? Also by bridging, the positives from the O2's would be together and use both the positive from 3rd and 4th channel? And the negatives would be wound together also and use both the negatives on the amp?

I have one set of 4 ohm rockford components, and 2 individual 8ohm O2 audio speakers. Why question is should i run the rockfords off channel 1 and 2, and run the 2 O2's in parallel down to 4 ohm on the 3rd channel. OR run the rockfords how i mentioned earlier, or run 1 O2 off the 3rd channel and the other off the 4th channel

So i ordered 2 O2 audio speakers and though i was getting 4 ohm speakers, but they were 8 and i put down a deposit so i got stuck with them. Im using a Sundown audio 100.4 amp. I have a pair of RF T2's im running off the first two channels. I plan on running my two 8 ohm speakers in parallel on the third pair of channels and leaving the 4 set open. Will these speakers see 100 watts each? If i just ran them each off the 3rd and 4th channel this would damage the amp correct being that the rockfords are 4 ohm?

As the title says what are you guys using your 100.4's for? What comp sets, mid's, tweets etc

by pass thru you mean the output from my other amp? Would running the fronts off the remaining open RCA and splitting the rears to the Sub and the rear inputs on the sundown be the best bet? this is the headunit: http://www.crutchfield.com/S-OzOQ9uU4hcr/p_1303200UB/Pioneer-DEH-3200UB.html

This is my first 4-channel amp. I had a few questions as far as what to do being i only have one RCA output remaining from my deck. Does this amp have a 1 channel input mode? If not would using a splitter be a viable option, or would using the output from my other amp work. Also what size power wire and what size speaker wire should i use if im going to be running at 4-ohm?

Im deciding between these three MB Quart 125.4 or Hifonics 100.4 or PPI 760.4 to run 2 set of Rockford T2's comps. Which would you guys recommend, i wanna run them at 4 ohm.

So using the output from my AQ and the output from the headunit wouldnt be a good idea?

15 inch XL AQ2200D (2) XS 1200D batt's 3.5 cubes after disp 0gauge knu including big 3 200 amp alt

trying to run 2 sets of RF T1's, looking for an amp now was going to get a AQ 90x4 but there being replaced by a 120x4 and not out yet, i dont know what to get all i know is that i wanna spend under $250 and give the RF's all they can take...safely.

When a 4 channel amp has a L/R input for the front and L/R input for rear, and my head unit only has 2 L/R outputs, and 1 is taken by the sub. How do u wire that? Will one set of inputs be enough for the amp to put out at 4 channels? Also what does the 4/3/2 channel switch control? Also is it possible to just take the output from my other amp into the remaining open L/R on the 4 channel? i know its a wordy question i appologize