baldwin3m

Nope - Please read the rules

yeah i just graduated high school in bloomington. takin a year off then going to iu.

Im buying a xs power D5100, it will be under the hood pushing 2 sa-12s and a saz-1500, 250amp fuse, 0 awg wires. Are there any accesories that i would need to install the battery? Do you think it is a big enough battery to push this system?

yeah im workin on a build right now. 2 sa-12 and a saz-2500. (all i can afford now) but yeah indiana university is where im at.

Any hoosier bassheads out there???? make a shoutout!

okay thanks guys for the help.

so do you think a 200? or 250? i dont wanna get one that is too big cause i heard that was bad

Hey guys what fuse size should i get for a AQ2200 running 2 SA-12s? And also would a XS 12V D975 AMG battery be enough to power this?

^^that really confused me haha sorry for makin it difficult on everyone (FIGURED IT OUT) another question popped into my mind as well, what is the difference between copper and aluminum voice coils? which one is better? also should i invert these subs or not? i had my jl w3s inverted for a bit, and they sounded pretty good, hit the low notes harder.

my bass is noticeable louder when my trunk is closed so i will probably end up facing the port towards that trunk. The car is an 06 but i dont know if it has had a new battery put in, i assume not. Also how many ft of 1/0 awg wire would i need, i just need an estimate. Also what brand wiring should i get? ^^ So i leave both the positives from one side and both the negatives from one side untouched for wiring at 1ohm? What about getting a capacitor or volt reader?

also which way should i face these subs and the port? rear, front, up? i want maximum SPL too.

42in is the width of the opening to my trunk. my trunk is much wider than 42 inches i just wanna be able to fit the box in there without any hassle. and that design looks good, ill keep in touch for when im ready for the box. could you build it and ship it? if not its fine.

the big 3 are putting you batt negative on the chassis, alt to batt positive and chassis to engine? thats what a website said the big 3 are, im a little confused on how to do it but i will hopefully be able to figure it out.

I plan on upgrading my battery and alt, but it would be a little bit after getting my subs and amp. and i have 3 A pillars in my car (i think), its a 2006 4dr toyota corolla. i would also need help figuring out how to wire stuff at 1ohm and all that, i have no clue what any of you are talking about when it comes to wiring things at Ohms, sorry for being such a noob with everyone haha

What are A pillars? and im running 2 memphis tweeters, 2 memphis 6.5" and 2 memphis 6X9 with no amp. Sorry for all the noob questions