Chris Lamp

I'm planning on doing a true 3800watt max system with a high output alt and a xspower xp950 battery in the back hooked up to a battery isolator. What battery should I go with up front for starting? I have a 98 chevy blazer, I'm limited on space and need to use side post adapters.

Thanks thats what I was thinking but wasn't sure.

Alright I have a old set of power acoustik mofo 12's sitting around the house, I'm bored so I figured I would wire them to 1ohm and see what they got, I took both of them out of the box and here I have 1 2ohm sub and 1 4ohm sub. Is there any way to make these work at 1ohm if not whats the best way to wire these or would I just be better off running 1? O yeah my amps are 2x P.A. bamf 4000/1D's strapped

0* tune one amp with that, then use a DMM to gain match the second amp. then strap them together. thats how i always did it. except without a dd-1 Hmm never used a Multimeter, any tutorial suggestions on what to do in this scenario?

Looks like I get to break out my trusty SMD Distortion Detector DD-1 again

Ok thanks for the info, I guess I'll try to strap them together tomorrow.

I have two Power Acoustik bamf 4000/1Ds hooked up to two Power Acoustik 12" mofos, I put the two rcas into the first amps input L channel and R channel and have the switch to master. I then ran a single rca cable from the master out with a rca (splitter or Y) to the slave in and also tried the input L channel R channel. I tinkered with the phase and and all the other settings but can't get both subs to hit the same. Any suggestions on a way to setup each amp up or both the same way. And also with this amp being mono should I hook both positives to my postive box terminals and both negatives to my negative box terminals or is it recomended I hook it up another way? thanks for your time.