Deadly hertzz

Miiiiiiiight be getting rid of my truck after the season and doing a 4th n a Burban but if I could trade me sa's in for x's and pay the difference or even if another audio company would do a trade in like that cuz it'd be hard to find someone to buy all 8 of my subs lol

Anybody know any companies that do trade ins like say, trade in set amount of subs to upgrade to a bigger line and pay off the difference

Yep your right completely different but that wasn't what the thread was about so that's why I was confused about him sayin if I didn't want Input on it don't start a thread and I never once started a thread about my "speakers"

Oh Ok, cuz that's not what the thread was about

Somebody out of nowhere started a whole convo about my mids and highs thats where all of that came from, I get what your saying about the level control knob up when setting Ile re do it like that then

Kirill what are you talking about ? Better performance with less speakers I have 8 sa 12s in a wall and I'm setting the gain on an saz3000

After I reset everything without the line driver and with the knob adjusted, I didn't play full tilt but half volume I could tell that actually turning it down turned it down adm turning it up turned it up since I set it with the knob in the middle, so hopefully that fixed my problem I didnt WANa smoke any subs and the dd1 is handy once you figure out how to properly set everything to use it, thanks everyone

Also I just reset it without the line driver and with the knob at halfway when I was on break at work a minute ago but haven't got a chance to turn it up since I'm out there n the parking lot

^ I understand but say I set it with the eq to flat but then once it's all set I turn the eq back on won't it send it to clipping since the signal will be a tad higher then with it to flat

Exactly right I was using it to set the gain with previous amps, so after work Ile drop the line driver and re tune it with just straight rca's and the knob all the way up and see how it comes out, thanks, and yeh it is just an added piece that makes it more complicated and another piece that has to be dd1'd but Ile give it a try after work and see how it sounds thanks alot

Idk!!!! What u want man lol is there something wrong with that also ? That' I have each set of speakers wired to each other then on each channel, the 2 powers together to 2 ohm each set of tweeters together to 4 ohm etc....

My original post was about the dd1 anyhow not any speakers or 4 channel or any of that my doors touch the seat in almost every spot except one open spot where I'm doing the pods and that's just how it's gonna be, to anyone still following the thread, just drop the line driver and re set the gain with the remote knob all the way up correct ? And also what would the outcome be when dd1'ing with the remote knob unhooked completely then Hooked back up after tuning ?

Not hard it's not like everyone with crazy doors with 60 speakers In a car has 15 4 channel amps in their car

I don't have rear speakers I have all the speakers wired together to either 2 or 4 ohms on each channel, when the doors are done Ile have the the 2 in the center console on the amp the a pillars on the amps and the 4 nendos in the doors on the amp, my head unit will stay powering the alpine components in the doors because I see no point in unhooking something for 0 reason and once again the amp will already have 8 speakers on it again......

Ile be taking the overhead tweeters and the onyx speakers out when my doors are finished and running 2 on each channel but I don't understand the logic of I have the door speakers playing or I can unhook them For no reason at all?